You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
The <strong>PK</strong>-<strong>232</strong> uses the 1,000 Hz wideshift filters which have a center<br />
frequency of 1.7 KHz for copying facsimile transmissions. As a<br />
result, you must tune 1.7 KHz lower than the frequencies listed in<br />
Table 1 when using Upper Sideband. Similarly; in Lower Sideband, one<br />
must tune 1.7 KHz higher than the frequencies listed in the table.<br />
The <strong>PK</strong>-<strong>232</strong> LED bar-graph should be tuned so that the facsimile signal<br />
is roughly centered in the display as shown in the middle of Figure 1<br />
below. If the audio frequency is too low, the bar-graph will look<br />
something like the left-most display. If the audio frequency is too<br />
high, it will look something like the right-most display. Facsimile<br />
tuning is not especially critical when copying WEFAX, but a properly<br />
tuned signal is needed when printing facsimile photographs.<br />
M S M S M S<br />
Frequency too low Tuned In Frequency too High<br />
Figure 1: Facsimile tuning indicator conditions for FAX tuning<br />
9.3.3 <strong>PK</strong>-<strong>232</strong> Facsimile Parameter Settings<br />
To start receiving WEFAX broadcasts on your computer screen, follow<br />
the setup instructions in your PAKRATT WITH FAX program manual.<br />
To start receiving FAX on your graphics compatible printer, you first<br />
must tell the <strong>PK</strong>-<strong>232</strong> that there is a parallel printer connected by<br />
issuing the command PRCON ON. The <strong>PK</strong>-<strong>232</strong> will respond with:<br />
PRCon was OFF<br />
PRCon now ON<br />
At this point you will observe that the STA, CON, STBY, and <strong>PK</strong>T LEDs<br />
are on. The MULT LED may also be on if the printer is "Off Line" or<br />
is not connected to the <strong>PK</strong>-<strong>232</strong>. This is normal whenever the printer<br />
command PRCON is ON and is nothing to worry about. Turning PRCON OFF<br />
will return the LEDs to their normal status indicating function.<br />
Now all that is necessary is to put the <strong>PK</strong>-<strong>232</strong> into FAX mode by typing<br />
FAX. The <strong>PK</strong>-<strong>232</strong> will respond with:<br />
Opmode now FAx<br />
9.4 Receiving Facsimile Broadcasts<br />
The <strong>PK</strong>-<strong>232</strong> is now in the Facsimile Standby-Receive mode which means it<br />
is waiting for a synchronization signal from a facsimile transmitter<br />
to begin a new picture. Verify this by entering the OPMODE command.<br />
The <strong>PK</strong>-<strong>232</strong> should respond with:<br />
Opmode FAX<br />
STBY RCVE<br />
4/91 9-3<br />
From The <strong>N3UJJ</strong>.COM Document Library