Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>PK</strong>-<strong>232</strong> OPERATING MANUAL Pactor OPERATION<br />
If the tuning indicator looks like the one below, the audio frequency from<br />
your speaker is too high for the <strong>PK</strong>-<strong>232</strong> to copy packets. Slowly tune the<br />
VFO and make the frequency lower.<br />
Frequency Too High<br />
• Adjust the <strong>PK</strong>-<strong>232</strong> front panel THRESHOLD control so that the DCD LED<br />
lights when a properly tuned Pactor station is being received.<br />
After you have a Pactor station tuned in, you should start seeing the copy<br />
on your screen.<br />
11.6 <strong>Operating</strong> on Pactor<br />
Make sure your <strong>PK</strong>-<strong>232</strong> is adjusted for your SSB transmitter as described in<br />
section 2.4.3 of this manual before transmitting. These are very critical<br />
adjustments. If your <strong>PK</strong>-<strong>232</strong>'s APSK level and transmitter microphone gain<br />
are not adjusted properly, other stations will not be able to copy your<br />
signals. Check your plate or collector current or the power output of<br />
your rig before transmitting.<br />
11.6.1 Going on The Air<br />
Make sure your transmitter and antenna are tuned and adjusted for the band<br />
and operating frequency you are using. Before you transmit, you must<br />
decide if you are going to "call CQ” or answer someone's CQ call.<br />
11.6.2 Calling CQ In Unproto Pactor<br />
If you plan to make a CQ call, you must do so in the unproto Pactor mode.<br />
This is required since an ARQ Pactor transmission requires another station<br />
to 'Link-up" with. If you are using a Timewave terminal program, see the<br />
program manual to place the <strong>PK</strong>-<strong>232</strong> into unproto transmit. If you are<br />
using a terminal or terminal emulation program, the following will place<br />
your <strong>PK</strong>-<strong>232</strong> and transceiver into the transmit mode.<br />
• Type "PTSEND" then press the key to key your transmitter and<br />
automatically enter Pactor unproto transmit mode.<br />
As soon as you type the key you will be transmitting At this<br />
point you are also in the CONVERSE mode and anything you type will be<br />
sent in unproto Pactor by your transmitter.<br />
1/93 11-4<br />
From The <strong>N3UJJ</strong>.COM Document Library