You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
______________________________________________________________________________<br />
NOmode ON|OFF<br />
Default: OFF<br />
Mode: All<br />
Host: NO<br />
_________________________________ Parameters: _________________________________<br />
ON - The <strong>PK</strong>-<strong>232</strong> switches modes only upon explicit command.<br />
OFF - The <strong>PK</strong>-<strong>232</strong> changes modes according to NEWMODE.<br />
_______________________________________________________________________________<br />
When NOMODE is OFF (default), your <strong>PK</strong>-<strong>232</strong> switches modes automatically according<br />
to NEWMODE. When NOMODE is ON your <strong>PK</strong>-<strong>232</strong> never switches from Converse or<br />
Transparent Mode to Command Mode (or vice versa) by itself. Only specific<br />
commands (CONVERSE, TRANS, or ) typed by you change the operating mode.<br />
______________________________________________________________________________<br />
NUCr ON|OFF<br />
Default: OFF<br />
Mode: All<br />
Host: NR<br />
_________________________________ Parameters: _________________________________<br />
ON - characters ARE sent to the terminal following characters.<br />
OFF - characters ARE NOT sent to the terminal following s.<br />
_______________________________________________________________________________<br />
The NULLS command sets the number of characters that will be sent.<br />
Some older printer-terminals require extra time for the printing head to do a<br />
carriage return and line feed. NUCR ON solves this problem by making your<br />
<strong>PK</strong>-<strong>232</strong> send characters (ASCII code $00) to your computer or terminal.<br />
_______________________________________________________________________________<br />
NULf ON|OFF<br />
Default: OFF<br />
Mode: All<br />
Host: NF<br />
_________________________________ Parameters: _________________________________<br />
ON - characters are sent to the terminal following characters.<br />
OFF - characters are not sent to the terminal following s.<br />
_______________________________________________________________________________<br />
Some older printer-terminals require extra time for the printing head to do a<br />
carriage return and line feed. NULF ON solves this problem my making your<br />
<strong>PK</strong>-<strong>232</strong> send characters (ASCII code $00) to your computer or terminal. The<br />
NULLS command sets the number of characters that will be sent.<br />
_______________________________________________________________________________<br />
NULLs "n"<br />
Default: 0 (zero)<br />
Mode: All<br />
Host: NU<br />
_________________________________ Parameters: _________________________________<br />
"n" - 0 to 30 specifies the number of characters to be sent to your<br />
computer or terminal after or when NUCR or NULF are set ON.<br />
_______________________________________________________________________________<br />
NULLS specifies the number of characters (ASCII $00) to be sent to the<br />
terminal after a or is sent. NUCR and/or NULF must be set to indicate<br />
whether nulls are to be sent after , or both. The null characters are<br />
sent from your <strong>PK</strong>-<strong>232</strong> to your computer only in Converse and Command Modes.<br />
4/91 A-60<br />
From The <strong>N3UJJ</strong>.COM Document Library