PK-232 MBX Operating Manual - N3UJJ

More documents

Recommendations

Info

PK-232 OPERATING MANUAL COMMAND SUMMARY PTHUFF “n” Default: 0 Mode: Pactor Host: pH "n" — 0 to 3, specifying a type of compression that may be used in Pactor. To enhance the effective data rate in Pactor, a data compression scheme called may be automatically enabled. 0 - is no compression (default). 1 - is Huffman encoding. 2,3 - presently not implemented but reserved for future use. Instead of using the normal 8 bit ASCII representation of a character, Huffman encoding assigns each character a code that may be as few as 2 bits for the most used characters to as long as 15 bits for the least used characters. For English (and most other) languages, the use of Huffman compression results in a smaller number of bits necessary for a given message. For messages consisting of nontext information such as computer programs, Huffman compression would need more bits than ASCII and would be less efficient. If PTH is set off, Pactor will never use Huffman compression. When PTH is set on, Huffman compression will be used if it is more effective. Do not use Huffman compression with binary file transfers as it only works with 7 bit data. PTList Mode: Pactor Immediate Command Host: PN PTList is an immediate command that switches your PK-232 into the Pactor listen mode. You can usually monitor a Pactor contact between two connected stations using the Pactor listen mode. Since your station is not part of the error free link, if the CRC check does not produce a correct check sum, nothing will be displayed. If the receiving station requests a repeat, and you have copied the packet, it will not print twice. PTOver “n” Mode: Pactor Default: ($lA) Host: PV “n” — A hexadecimal value from $00 to $7F used to select the change-over character used in linked Pactor. The default is . PTOver is the character, conventionally , that is used to change the direction of data transmission in a linked Pactor operation. When you are finished transmitting information and you are ready to receive information from the other station, use the PTOver character. Also see AChg. 2/93 A-65b From The N3UJJ.COM Document Library
PK-232 OPERATING MANUAL COMMAND SUMMARY PTSend – “n, x” Default: 1,2 Mode: Pactor Host: PD Parameters: ”n” - 1 or 2 selects the transmit baud rate. - 1 to 5 selects the number of times the data is repeated. PTS “n, x” initiates an unproto Pactor transmission. To end the transmission, type . “n” 1 selects 100 baud, 2 selects 200 baud. In order to increase the probability of correct transmission, the unproto Pactor transmission sends the message data a selected number of times. The parameter x sets the number of times the data is sent. Example: PTS 1 3 would start a 100 baud unproto transmission with the message data sent three times. The transmission may be started using the default, 100 baud, two repeats, by typing "PTS" without “n x.” Example: PTS 2/93 A-65c From The N3UJJ.COM Document Library
Page 1 and 2:
PK-232 MBX Operating Manual MODEL P
Page 3 and 4:
PREFACE TO THE PK-232 OPERATING MAN
Page 5 and 6:
Timewave address is: Timewave Techn
Page 7 and 8:
CHAPTER 3 - RADIO INSTALLATION (Con
Page 9 and 10:
CHAPTER 5 - MAILDROP OPERATION (Con
Page 11 and 12:
CHAPTER 7 - AMTOR AND NAVTEX OPERAT
Page 13 and 14:
Table of Contents CHAPTER 11 - Pact
Page 15 and 16:
1.2 Computer or Computer Terminal R
Page 17 and 18:
1.4.4 Controls and Indicators Front
Page 19 and 20:
2.2.1 Connecting Power o o o o o MA
Page 21 and 22:
2.3.2 Apple Macintosh Series of Com
Page 23 and 24:
Follow the installation directions
Page 25 and 26:
Make note of the firmware Release d
Page 27 and 28:
2.6 Detailed RS-232 Connections for
Page 29 and 30:
If your computer requires any other
Page 31 and 32:
PK-232 OPERATING MANUAL RADIO INSTA
Page 33 and 34:
3.3.5 Begin Assembling your Radio C
Page 35 and 36:
3.3.6 Wiring Your HF Transceiver fo
Page 37 and 38:
3.4 PK-232 Configuration Jumpers an
Page 39 and 40:
o Listen to the monitor receiver; t
Page 41 and 42:
EXAMPLE: If the manufacturer's plat
Page 43 and 44:
4.2 Packet Introduction You've now
Page 45 and 46:
9. You have just done the three thi
Page 47 and 48:
4.3.2 What It Means There are diffe
Page 49 and 50:
4.3.3 What Happens When You Connect
Page 51 and 52:
NET/ROM, developed by Software 2000
Page 53 and 54:
After pressing , you should observe
Page 55 and 56:
4.4.4 Digipeater Details You may wi
Page 57 and 58:
If you are hearing packets that sou
Page 59 and 60:
4.4.7.2 Canceling Lines and Packets
Page 61 and 62:
4.5.1 Unconnected Packets In order
Page 63 and 64:
4.6.2 The Channel Switching Charact
Page 65 and 66:
o Make certain your HF receiver is
Page 67 and 68:
PK-232 OPERATING MANUAL PACKET RADI
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
The number "18396 free" is the RAM
Page 77 and 78:
E Shows the following short help fi
Page 79 and 80:
Enter a short (up to 27 character)
Page 81 and 82:
L {The LIST command} {The MailDrop
Page 83 and 84:
Msg# Size To From @ BBS Date Time T
Page 85 and 86:
- Use the Edit command to set the F
Page 87 and 88:
6.2.2 HF Receiver Settings Set your
Page 89 and 90:
6.4 A Typical Baudot RTTY Contact A
Page 91 and 92:
6.5.3 Formatting Your Transmitted a
Page 93 and 94:
The following parameters are the mo
Page 95 and 96:
See the MYSELCAL command in the Com
Page 97 and 98:
7.3 Transmitter Adjustments Make su
Page 99 and 100:
o Type to stop sending when the tr
Page 101 and 102:
7.4.4 Echoing Transmitted Character
Page 103 and 104:
7.6.4.1 Remote Logon to your AMTOR
Page 105 and 106:
7.6.8.4 J (JLOG) (Remote only comma
Page 107 and 108:
7.8 NAVTEX Operation NAVTEX is an i
Page 109 and 110:
o When you find a station, slowly v
Page 111 and 112:
8.4.3 Sending Only Complete Words (
Page 113 and 114:
9.3 System Setup If you own CSS HF
Page 115 and 116:
At this point make sure the THRESHO
Page 117 and 118:
9.8 Adjusting the PK-232 4.0 MHz Ma
Page 119 and 120:
o When you find a station, slowly v
Page 121 and 122:
PK-232 OPERATING MANUAL SIAM AND TD
Page 123 and 124:
PK-232 OPERATING MANUAL Pactor OPER
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
PX-232 OPERATING MANUAL Pactor OPER
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
A.2.2 Default Values Almost all com
Page 141 and 142:
was now Whenever you change one of
Page 143 and 144:
?VIA You typed more than one call s
Page 145 and 146:
___________________________________
Page 147 and 148:
___________________________________
Page 149 and 150:
___________________________________
Page 151 and 152:
___________________________________
Page 153 and 154:
ARQE Immediate Command Mode: Comman
Page 155 and 156:
___________________________________
Page 157 and 158:
___________________________________
Page 159 and 160:
___________________________________
Page 161 and 162:
___________________________________
Page 163 and 164:
When CHCALL is OFF, the monitored a
Page 165 and 166:
PK-232 OPERATING MANUAL COMMAND SUM
Page 167 and 168: PK-232 OPERATING MANUAL COMMAND SUM
Page 171 and 172: ___________________________________
Page 173 and 174: ___________________________________
Page 175 and 176: ___________________________________
Page 177 and 178: ___________________________________
Page 179 and 180: 8/91 A-36b From The N3UJJ.COM Docum
Page 181 and 182: ___________________________________
Page 187 and 188: FSPEED, 8" width (narrow) FSPEED 13
Page 189 and 190: ___________________________________
Page 191 and 192: ___________________________________
Page 193 and 194: ___________________________________
Page 195 and 196: ___________________________________
Page 197 and 198: ___________________________________
Page 199 and 200: MFROM determines what packets are m
Page 201 and 202: ___________________________________
Page 203 and 204: ___________________________________
Page 209 and 210: ___________________________________
Page 215 and 216: When your computer has queued data
Page 217: PK-232 OPERATING MANUAL COMMAND SUM
Page 221 and 222: ___________________________________
Page 227 and 228: ___________________________________
Page 229 and 230: ___________________________________
Page 231 and 232: ___________________________________
Page 233 and 234: When TRFLOW is ON, the type of flow
Page 243 and 244: PK-232 OPERATING MANUAL APPENDIX B
Page 245 and 246: PK-232 OPERATING MANUAL APPENDIX C
Page 247 and 248: DS16-DS20 314-302 DS10,DS11 LED GRN
Page 249 and 250: D PK-232 OPERATING MANUAL ALINCO Fi
Page 251 and 252: D TM-421 3 TM-431 53 7 TM-441 3 TM-
Page 253 and 254: D 1 G G G 2 3 RX Audio: EXT SPKR Ja
Page 255 and 256: D 1:1 Transformers 25 PTT Shield 28
Page 257 and 258: D 0 ® ® ® RX Audio: Use EXT SPKR
Page 259 and 260: D CQ, 4-25, 6-4, 7-1, 7-4, 8-2, 8-3
Page 261 and 262: D NAVSTN, 7-10, A-59 NAVTEX, 1-1, 7
Page 263 and 264: D PK-232 MBX OPERATING MANUAL COMMA
Page 265 and 266: D PK-232 MBX OPERATING MANUAL COMMA
show all

PK-232 MBX Operating Manual - N3UJJ

Create successful ePaper yourself

Delete template?

Save as template?