PK-232 MBX Operating Manual - N3UJJ

PK-232 OPERATING MANUAL
COMMAND SUMMARY
KYSelcal ease
Mode: AMTOR
Parameters:
Default: none
Host: MG
sees -
Specifies your SELective CALling code (SELCALL)
Use the MYSELCAL command to enter the SELCALL (SELective CALLing) code required
in AMTOR ARQ (Mode A) and SELFEC operating modes. MYSELCAL is a unique character
string which must contain four alphabetic characters and is normally derived from
your call sign.
Amateurs may simply enter their callsign and the PK-232 will automatically
translate it to a 4-character SELCALL using the grouping table below:
GROUP CALL SELCALL
I by2 WIXY WWXY
I by3 W1XYZ WXYZ
2 by1 ABIX AABX
2 by2 ABLXY ABXY
2 by3 KAIXYZ KXYZ
Although the convention is to form the SELCALL from the call sign, your PK-232
can include any AMTOR character in the SELCALL. In accordance with CCIR
Recommendation 491, four- or five-digit numbers may be entered; the PK-232
automatically translates the numeric entry to your four-letter alpha SELCALL.
NAVMsg all, none, Yes/No (letters)
Mode:
Parameters:
Default: All
NAVTEX Host: NM
letters
all, none, YES List, NO List. List of up to 13 letters which may
or may not be separated by spaces, commas or TABS.
NAVMSG uses Letter arguments to determine which NAVTEX messages your PK-232 will
print. NAVTEX messages are grouped into classes by the second letter in the
Preamble. The NAVMSG Command allows ALL, NONE or a list of up to 13 letters
representing message types to be Monitored or Rejected.
NAVY-SG may be cleared with “%”, “&” or "OFF” as arguments.
2/93 A-58a
From The N3UJJ.COM Document Library