PK-232 MBX Operating Manual - N3UJJ

_______________________________________________________________________________
DFrom all,none,yes/no call1[,call2..]
Default: all
Mode: Packet
Host: DF
_________________________________ Parameters: _________________________________
call - all, none, YES list, NO list.
list of up to eight call signs, separated by commas.
_______________________________________________________________________________
DFROM determines how your PK-232 responds to stations trying to use your station
as a digipeater. DFROM is set to "all" when you first start your PK-232.
Type DFROM to display the ALL/NONE/YES_list/NO_list status of station's call
signs whose packets will or will not be repeated.
To prevent all stations from digipeating through your station, type DFROM NONE.
To permit one or more specific stations to digipeat through your station, type
DFROM YES (followed by a list of calls signs). Packets will be digipeated only
from stations whose call signs are listed.
To prevent one or more specific stations to digipeat through your station, type
DFROM NO (followed by a list of call signs). Packets will not be digipeated
from stations whose call signs are listed.
Clear DFROM with "%" "&" or "OFF" as arguments.
_______________________________________________________________________________
DIDdle: ON|OFF
Default: OFF
Mode: Baudot, ASCII
Host: DD
_________________________________ Parameters: _________________________________
ON - In Baudot, the PK-232 will send the LTRS character when idling.
In ASCII, the PK-232 sends the NULL (00) character.
OFF - No characters are sent when idling in transmit.
_______________________________________________________________________________
In the RTTY modes, it may be desirable to continue sending some data while
paused at the keyboard. With DIDDLE on, the PK-232 will send idle characters
when waiting for keyboard entry.
________________________________________________________________________________
Disconne
Immediate Command
Mode: Packet
Host: DI
_______________________________________________________________________________
DISCONNE is an immediate command that initiates a disconnect command to the
distant station to which you are connected. If your disconnect command is
successful, your monitor will display:
*** DISCONNECTED: (call sign)
Other commands can be entered while a disconnect is in progress.
New connections are not allowed until the disconnect is completed.
o
If another disconnect command is entered while your PK-232 is trying to
disconnect, your PK-232 will instantly switch to the disconnected state.
8/91 A-36
From The N3UJJ.COM Document Library