PK-232 MBX Operating Manual - N3UJJ

_______________________________________________________________________________
MDCheck
Immediate Command
Mode: AMTOR Packet/MailDrop
Host: M1
_______________________________________________________________________________
MDCHECK is an immediate command which allows you to log on to your own MailDrop.
After logging on, you can EDIT, LIST, READ, SEND or KILL MailDrop messages.
To use the MDCHECK command, and your PK-232 must not be connected to or linked
to any packet or AMTOR stations. For monitoring purposes, local access of the
MailDrop is considered a connection. Type "B" (BYE) to quit local control of
your MailDrop.
_______________________________________________________________________________
MDigi ON|OFF
Default: OFF
Mode: Packet
Host: MD
_________________________________ Parameters: _________________________________
ON - I and UI frames having your call sign (MYCALL or MYALIAS) as the next
digipeater in the field are displayed, regardless of connected status.
OFF - Normal monitoring as determined by the monitoring mode commands.
_______________________________________________________________________________
MDIGI permits you to display packets when another station uses your station as a
digipeater. If you want to monitor ALL traffic that flows through your packet
station, set MDIGI ON.
You may not want to see all the data passing through your station, especially if
many others use you as a digipeater. In this case set MDIGI OFF (default).
_______________________________________________________________________________
MDMon ON|OFF
Default: OFF
Mode: AMTOR and Packet/MailDrop
Host: Mm
_________________________________ Parameters: _________________________________
ON - Monitor a calling station's activity on your MailDrop.
OFF - Normal monitoring as determined by the monitoring mode commands.
_______________________________________________________________________________
Set MDMON to ON to monitor activity on your MailDrop.
MDMON permits you to monitor activity on your AMTOR or packet MailDrop showing
you both sides of the QSO. Packet headers are not shown while a caller is
logged on. When no one is connected to your MailDrop, channel activity is
monitored according to the setting of MONITOR.
Set MDMON OFF to cancel MailDrop monitoring. Note that MailDrop connect and
link status messages will be displayed even with MDMON OFF. These status
messages are important and allow you to see who is connected to your MailDrop.
They can be disabled however with the UBIT 13 command. See the UBIT command for
more information .
8/91 A-50
From The N3UJJ.COM Document Library