You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
_______________________________________________________________________________<br />
REDispla "n"<br />
Default: $12 <br />
Mode: All<br />
Host: RD<br />
_________________________________ Parameters: _________________________________<br />
"n" - 0 to $7F (0 to 127 decimal) specifies an ASCII character code.<br />
_______________________________________________________________________________<br />
REDISPLA changes the redisplay-line input editing character.<br />
Parameter "n" is the numeric ASCII code for the character you'll use when you<br />
want to re-display the current input line.<br />
Type the REDISPLA character (default ) to re-display a command or text<br />
line you've just typed. This can be helpful when editing a line especially if<br />
your terminal does not support . It can also be used in Packet to<br />
display a packet that might have been received while you were typing. A<br />
is appended to old line, and the corrected line is shown below it.<br />
_______________________________________________________________________________<br />
RELink ON|OFF<br />
Default: OFF<br />
Mode: Packet<br />
Host: RL<br />
_________________________________ Parameters: _________________________________<br />
ON - The <strong>PK</strong>-<strong>232</strong> will try to automatically reconnect the distant station<br />
after the link has timed out on retries.<br />
OFF - The <strong>PK</strong>-<strong>232</strong> will not attempt to re-establish the failed link (default).<br />
_______________________________________________________________________________<br />
Set RELINK ON if you want the <strong>PK</strong>-<strong>232</strong> to automatically try to reconnect to a<br />
distant packet station if the link fails.<br />
_______________________________________________________________________________<br />
RESET<br />
Immediate Command<br />
Mode: Command<br />
Host: RS<br />
_______________________________________________________________________________<br />
RESET is an immediate command that resets all parameters to <strong>PK</strong>-<strong>232</strong>'s PROM<br />
default settings and reinitializes the <strong>PK</strong>-<strong>232</strong>. All personalized parameters,<br />
monitor lists and MailDrop messages will be lost.<br />
_______________________________________________________________________________<br />
RESptime "n"<br />
Default: 0 (000 msec.)<br />
Mode: Packet<br />
Host: RP<br />
_________________________________ Parameters: _________________________________<br />
"n" - 0 to 250 specifies 100-millisecond intervals.<br />
_______________________________________________________________________________<br />
RESPTIME adds a minimum delay before your <strong>PK</strong>-<strong>232</strong> sends acknowledgment packets.<br />
This delay may run concurrently with the default wait time set by DWAIT and any<br />
random wait in effect.<br />
During a file transfer, RESPTIME can help avoid data/ack collisions caused by<br />
the sending stations TNC pausing briefly between transmitted data frames.<br />
4/91 A-67<br />
From The <strong>N3UJJ</strong>.COM Document Library