Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
PX-<strong>232</strong> OPERATING MANUAL<br />
Pactor OPERATION<br />
11.9.3 Starting Pactor MailDrop Operation<br />
Remote access to your Pactor MailDrop is controlled by the command TMAIL<br />
which is short for TOR MAIL. The TMAIL command controls remote access to<br />
the Pactor and AMTOR MailDrop in the same way that the MAILDROP command<br />
controls remote Packet access.<br />
Turn the TMAIL command ON (default OFF) to allow remote stations to access<br />
your MailDrop in ARQ Pactor. Turn TMAIL OFF to have normal ARQ QSOO with<br />
other stations in the Pactor mode.<br />
11.9.4 Local Logon to the MailDrop<br />
To locally access your MailDrop use the MDCHECK command as described in<br />
Chapter 5 of this manual on MailDrop operation.<br />
11.9.4.1 Remote Logon to your Pactor MailDrop<br />
The Pactor MailDrop user interface is slightly different from the packet<br />
interface due to the differences between the two modes.<br />
When a station links with your Pactor MailDrop, your <strong>PK</strong>-<strong>232</strong> first<br />
identifies your station by sending your callsign and the amount of free<br />
MailDrop memory as shown below:<br />
Type H for help.<br />
(AEA <strong>PK</strong>-<strong>232</strong>M) 18956 free.<br />
The <strong>PK</strong>-<strong>232</strong> then sends the user the MTEXT string if the MailDrop<br />
Message command (MMSG) is ON. The Default text is shown below:<br />
Welcome to my AEA <strong>PK</strong>-<strong>232</strong><strong>MBX</strong> MailDrop.<br />
Type H for Help<br />
11.9.5 Caller Prompts<br />
The command prompt that the MailDrop sends the remote user in Pactor is<br />
similar to that used in the Packet mode and is shown below:<br />
WX7BBB DE WX7AAA (A,B,H,J,K,L,R,S,V,?) ><br />
As in packet, MDPROMPT is the Pactor MailDrop message prompt sent to a<br />
remote station by your MailDrop. The default prompt is:<br />
Subject:/Enter Message, IZ (CTRL-Z) or /EX to End<br />
Text before the first slash is sent to the user as the subject prompt;<br />
text after the first slash is sent as the message text prompt.<br />
11.9.6 Monitor MailDrop Operation<br />
The local user (SYSOP) can monitor the dialog by setting MDMON ON. The<br />
PX-<strong>232</strong> stays in command mode during remote MailDrop access.<br />
2/93 11-12<br />
From The <strong>N3UJJ</strong>.COM Document Library