Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
_______________________________________________________________________________<br />
MWeight "n" Default: 10<br />
Mode: All except Packet<br />
Host: Mw<br />
_________________________________ Parameters: _________________________________<br />
"n" - 5 to 15, specifies roughly 10 times the ratio of one dot length to one<br />
inter-element space length in transmitted Morse code.<br />
_______________________________________________________________________________<br />
A value of 10 results in a 1:1 dot-space ratio. A setting of 5 results in a<br />
0.5:1 ratio, while a setting of 15 (maximum) results in a 1.5:1 ratio.<br />
MWEIGHT applies only to the Morse transmit mode and the CW ID in all modes<br />
except packet. MWEIGHT does not affect the code output by the MID command.<br />
_______________________________________________________________________________<br />
MXmit ON|OFF<br />
Default: OFF<br />
Mode: Packet<br />
Host: Mx<br />
_________________________________ Parameters: _________________________________<br />
ON - Monitor transmitted packets in the same manner as received packets.<br />
OFF - Do not monitor transmitted packets.<br />
_______________________________________________________________________________<br />
When MXMIT is ON, transmitted packets are monitored in the same manner as<br />
received packets. The monitoring of transmitted packets is subject to the<br />
settings of MONITOR, MCON, MFROM, MTO, MRPT and TRACE. Most transmitted packets<br />
occur during connections so MCON should probably be set to a non-zero value.<br />
_______________________________________________________________________________<br />
MYAlias call[-n]<br />
Default: none<br />
Mode: Packet<br />
Host: MA<br />
_________________________________ Parameters: _________________________________<br />
call - Alternate packet digipeater identity of your <strong>PK</strong>-<strong>232</strong><br />
"n" - 0 to 15, an optional substation ID (SSID)<br />
_______________________________________________________________________________<br />
MYALIAS specifies an alternate call sign (in addition to the call sign specified<br />
in MYCALL) for use as a digipeater only. In some areas wide-coverage digipeater<br />
operators change their call sign to a shorter and easier to remember identifier.<br />
_______________________________________________________________________________<br />
MYALTcal aaaa<br />
Default: none<br />
Mode: AMTOR<br />
Host: MK<br />
_________________________________ Parameters: _________________________________<br />
aaaa - Your alternate SELective CALling code (SELCALL)<br />
_______________________________________________________________________________<br />
Use the MYALTCAL command to specify an your alternate SELCALL which, under<br />
certain conditions, may be convenient or necessary. You can enter an additional<br />
SELCALL code not related to your call sign. The alternate SELCALL can be any<br />
four alphabetical characters, or can be numeric strings of either four or five<br />
numbers. MYALTCAL is generally used for special applications such as receiving<br />
network or group broadcasts in AMTOR Mode B Selective (Bs or SELFEC).<br />
8/91 A-56<br />
From The <strong>N3UJJ</strong>.COM Document Library