PK-232 MBX Operating Manual - N3UJJ

______________________________________________________________________________
Help
Immediate Command
Mode: Command
Host: Not Supported
_______________________________________________________________________________
While in Command Mode, type the command "H" to read the abbreviated on-line HELP
file. Your monitor displays the following brief list:
Help:
AMtor PAcket AScii
ARq Connect BAudot
AList Disconne MOrse
FEc MHeard DISPlay
AChg CStatus CALibrat
NAvtex SIgnal FAx
TDm CONVerse Trans
Xmit Rcve Lock
RESTART RESET
MDCheck TClear
You can enter Command Mode at any time to list the HELP text.
_______________________________________________________________________________
HEReis "n"
Default: $02
Mode: Baudot, ASCII and AMTOR
Host: HR
_________________________________ Parameters: _________________________________
"n" - Is the hex representation ($01-$7F) of the character that causes the
AAB string to be sent in the middle of transmitted text.
_______________________________________________________________________________
If you wish to send your own AAB string for identification during a transmission
simply enter the HEREIS character (default ). Also see the command AAB.
_______________________________________________________________________________
HId ON|OFF
Default: OFF
Mode: Packet
Host: HI
_________________________________ Parameters: _________________________________
ON - Your PK-232 sends HDLC identification as a digipeater.
OFF - Your PK-232 does not send HDLC identification.
_______________________________________________________________________________
Set HID ON to force your PK-232 to send an ID packet every 9.5 minutes when it's
being used as a digipeater. Otherwise leave HID OFF (default).
This identification consists of a UI-frame with your station identification
(MYCALL) and MYALIAS in the data field. The packet is addressed to "ID".
NOTE:
You cannot change the 9.5-minute automatic interval timing.
8/91 A-43
From The N3UJJ.COM Document Library