You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
E Shows the following short help file:<br />
E msg#<br />
E msg# B/T/P<br />
E msg# Y/N/F<br />
E msg# >/ W0RM<br />
E 35 < WH1Z<br />
E 48 @ N7ML<br />
E 49 @ N7ML.MT.NA<br />
E 58 @<br />
E 60 P<br />
E 61 B<br />
E 62 T<br />
E 63 Y<br />
E 64 N<br />
E 49 F<br />
Shows message 12's info line<br />
Sets "W0RM" as message 23's destination<br />
Sets "WH1Z" as message 35's source<br />
Sets "N7ML" as message 48's destination BBS<br />
Sets "N7ML" as message 49's destination BBS<br />
and adds the hierarchical forwarding<br />
information .MT.NA signifying that N7ML BBS<br />
is located in the state of Montana (MT)<br />
which is located in North America (NA)<br />
Clears message 58's destination BBS field<br />
Sets message 60's status to Private<br />
Sets message 61's status to Bulletin<br />
Sets message 62's status to Traffic<br />
Sets message 63's status to Has-Been-Read<br />
Sets message 64's status to Has-Not-Been-Read<br />
Sets message 49's status to Reverse Forward<br />
The command "E n F" sets the message status to enable Reverse<br />
Forwarding of a message number. To cancel forwarding, set the status<br />
to either "Y" or "N." Please read the section on Reverse Forwarding<br />
(below) if you are interested in this feature.<br />
5.4.4 H (HELP) (Remote only command)<br />
The "H" command sends the distant station a HELP list of all available<br />
MailDrop commands as shown below. The "?" will also cause the HELP<br />
file to be sent.<br />
A(bort)<br />
B(ye)<br />
H(elp)<br />
J(log)<br />
K(ill)<br />
L(ist)<br />
R(ead)<br />
S(end)<br />
Stop Read or List<br />
Log off<br />
Display this message<br />
Display stations heard<br />
K n: Kill message number n<br />
KM : Kill messages you have read<br />
L : List message titles<br />
LM : List messages to you<br />
R n: Read message number n<br />
RM : Read all your unread messages<br />
S : Send a message to SYSOP<br />
S n: Send a message to station n<br />
V(ersion) Display TNC firmware version<br />
? Same as H(elp)<br />
5.4.5 J (JLOG) (Remote only command)<br />
The "J" command sent by the distant station will cause your MailDrop<br />
to send the <strong>PK</strong>-<strong>232</strong>'s MHEARD List to the station. This command is not<br />
available to you the SYSOP since you can simply enter MHEARD at the<br />
<strong>PK</strong>-<strong>232</strong> command prompt.<br />
8/91 5-4<br />
From The <strong>N3UJJ</strong>.COM Document Library