PathFinder Software Configuration Guide - Trilogy Communications

PathFinder Version 4.22 User Guide23.1 Speak listen, Private listen keyThis new key type is not included by default and must be added as explained in Chapter20.5. The icon shown on the Panel Configuration page is:23.1.1 Key Operation.‣ Down - Non-latching speak and listen. Mutes all other panel listens using the same keytype.‣ Up - latching listen. Second upward press cancels listen.Note:‣ Multiple listen keys can be simultaneously operated as the matrix provides full mixing.‣ The non-latching speak and listen (down press) does not require prior selection of theupward latch.23.1.2 IndicationsState Red YellowOff Not speaking Not listening, no signalpresentSteady Momentary speak Latched ListenFlashing (Medium Rate) Incoming ringing present(Irrespective of whether keyis latched on or not)Modulation Medium Rate to Off(If twinklers are enabled)Signal Present (Key notlatched to listen and noringing present)Modulation Slow Rate to OnSignal Present (Key latched(If twinklers are enabled)to listen and no ringingpresent)Flashing Fast whilst key pressed Speak inhibited Listen function inhibited.23.2 Blip KeyThis key type allows a tone blip generated on the Misc. I/O logic card to be fired at anothercontrol panel. There is no additional “speak” facility associated with this key type.The key appears on the Panel Configuration form with this icon:The steps to program this operation are:i) Add a tone-blip key to the panel which will “fire” the blip.ii) Choose the style of tone-blip. From the Panel Config form, select the tone-blip viewin the lower right pane.Trilogy Communications LimitedIssue 1Page 143 of 143