PathFinder Software Configuration Guide - Trilogy Communications
PathFinder Software Configuration Guide - Trilogy Communications
PathFinder Software Configuration Guide - Trilogy Communications
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>PathFinder</strong> Version 4.22 User <strong>Guide</strong>17. TELEPHONES17.1 Introduction<strong>PathFinder</strong> provides comprehensive telephone support, allowing auto-hunting of a number ofphone lines from a single key for outgoing calls, and auto-routing of incoming calls to aspecific panel, or to a pre-configured set of panels. System wide Auto-dial numbers may beentered for speed dialling from panels. Additional hardware must be purchased andinstalled, as explained in the Installation <strong>Guide</strong>. Full facilities are only available if the TelosONE hybrid is used. This connects to the Commander matrix via the <strong>Trilogy</strong> 500-19 seriesTelephone Interface Unit. For correct operation, the port must be configured as a TelephonePort on the Overview (see below) and connected using 4 pair cable for audio and datatransfer.17.2 Configuring DTMF PortsFrom the System Overview, configure the port as Telephone Port and assign System Nameand labels.Now switch to the Telephone form, using the tab at the bottom of the screen.<strong>Trilogy</strong> <strong>Communications</strong> LimitedIssue 1Page 99 of 99