DataKeeper for Windows All Documentation - SIOS

1x1 Mirror CHANGEMIRRORENDPOINTS Command Example• Before making changes, it will be helpful to display Job Information for the volume. For example,emcmd . getJobInfoForVol D .• While making endpoint changes, the Job icon in the DataKeeper GUI may turn red. However, it willreturn to green after the ContinueMirror command is performed.In the following examples, we move mirrors from the 172.17.103 subnet to the 192.168.1 subnet. The basicsteps are as follows:1. Display job information for the volume2. Pause the Mirror using the EMCMD command line3. Change the IP address on the system(s) (if necessary)IMPORTANT: If you haven't already done so, prior to performing theCHANGEMIRRORENDPOINTS command, update the IP addresses for thesource and target. This will automatically place the mirror into the Paused state.4. Run EMCMD CHANGEMIRRORENDPOINTS to change to the new IP address1x1 Mirror CHANGEMIRRORENDPOINTS Command ExampleFor a 1x1 mirror (source and target only), one command is required.emcmd SYS1.MYDOM.LOCAL getJobInfoForVol DID = caa97f9f-ac6a-4b56-8f25-20db9e2808a8Name = Mirr Vol DDescription = Mirror Volume DMirrorEndPoints =SYS3.MYDOM.LOCAL;D;172.17.103.223;SYS1.MYDOM.LOCAL;E;172.17.103.221;Aemcmd SYS1.MYDOM.LOCAL PauseMirror Demcmd SYS1.MYDOM.LOCAL ChangeMirrorEndPoints D 172.17.103.223192.168.1.221 192.168.1.223emcmd SYS1.MYDOM.LOCAL getJobInfoForVol D. . .MirrorEndPoints =SYS3.MYDOM.LOCAL;D;192.168.1.223;SYS1.MYDOM.LOCAL;D;192.168.1.221;Aemcmd SYS1.MYDOM.LOCAL ContinueMirror DDataKeeper for Windows Technical DocumentationPage 65