DataKeeper for Windows All Documentation - SIOS

LOCKVOLUMERAW filesystemFAT filesystemACTIVE partitionContains PageFileGetDriveType not DRIVE_FIXEDIf the drive letter points to a newly created volume (i.e. SteelEye DataKeeper driver not attached yet), or anon-disk (network share, CD-ROM), the output will be:Unable to open - SteelEye DataKeeper driver might not be attached (you may need to reboot) or this might notbe a valid hard disk volume.If there is an internal error getting volume information, you may see the message:Error in GetVolumeInfo - You should never see this, but it is possible. It indicates a problem in the service or driver.LOCKVOLUMEEMCMD LOCKVOLUME This command forces an exclusive lock on the volume specified. This call will fail if a process owns openhandles into the volume. The parameters are:This can be either the source or the target systems. The drive letter of the volume you want to lock.MERGETARGETBITMAPEMCMD MERGETARGETBITMAP This command is for internal use only.PAUSEMIRROREMCMD PAUSEMIRROR []This command forces the mirror into a Paused state. The parameters are:This is the source system of the mirror to pause. Running the PAUSEMIRROR command onthe target has no effect.DataKeeper for Windows Technical DocumentationPage 82