SP-2000/X-Y AutoCam™ Pedestal - Vinten Radamec

SP-2000/X-YSafety & IntroductionSafe Operating Zone And Pedestal FootprintThe safe operating zone for personnel is a minimum of 3 feet (1m) outside of thepedestal footprint. This allows time for the personnel to avoid a pedestal thatstarts to move at its maximum speed of approximately 1 foot per second (0.3mper second).The pedestal footprint is typically larger than the pedestal base itself. In mostinstallations, the teleprompter is the piece of equipment mounted on the headthat protrudes the furthest beyond the base of the pedestal. Or, it may be themanual control bars on the rear that protrude the furthest. The footprint musttake into account the overhang of the teleprompter and/or manual control bars asthe head pans around.If your operating practices require personnel to work less than 3 feet (1m) outsidethe pedestal footprint, you must make sure that they are trained and areaware of the hazards of working in a robot environment, including the specifichazards listed below. The forces are sufficient to cause personal injury, or injuryto others and therefore, caution is essential.Pedestal Active LightsAt each corner of the base of the pedestal, a pair of lights will flash to indicatethat the pedestal is in motion, or may move at any time without additional warning.These lights are activated by Locate mode at the controller and do not operateif the pedestal is being controlled locally by the MCB controller.Pedestal In Motion Lights(2 East, 2 West, 2 North)1-6 User Manual