SP-2000/X-Y AutoCam™ Pedestal - Vinten Radamec

SP-2000/X-YInstallationRemoving The SP-2000/X-Y From Its CrateCAUTION: Do not try to push the pedestal off the base ofthe crate and down the ramp. You may cause serious electricaland/or mechanical damage.CAUTION: At least two people are needed to remove thepedestal from the crate.As shipped from the factory, the on board batteries of the SP-2000/X-Y are fullycharged. Therefore, unless the dolly is left crated for an extremely long time, itcan be driven off the skid under battery power using the ramp supplied. If youcannot drive the dolly under its own battery power, the alternate proceduredescribed below will require the temporary use of the AC power supply andpower/data cable.Uncrating The Pedestal1. The shipping crate is re-usable and should be saved for repacking the pedestalor should be shipped back to Vinten. Make sure that you retain thesides, top, ramp, interior brace and the four straps.2. Release the four straps that hold the crate together by pulling up on thelatch on each buckle. Remove the straps.Pull UpTo Release3. Using two or more people, lift the top of the crate and set it aside.3-4 User Manual