SP-2000/X-Y AutoCamâ¢ Pedestal - Vinten Radamec

More documents

Recommendations

Info

SP-2000/X-YMaintenance And RepairCylinder ReplacementWhen you check the column balance, if you find that gas needs to be added frequently,you may need to replace one or more of the three cylinders in the column.Remove the yellow dust caps and test each cylinder with a pressure gauge. Ifone or more cylinders is low relative to the others, use the following procedureto replace it.1. Lower the column to minimum height and power down the pedestal.2. Fully discharge the gas from the cylinders using the procedure in chapter 3.3. Remove the payload and head from the pedestal. Refer to the documentationfor the payload equipment and the User Manual for the pan/tilt headfor specific instructions.DANGER: DO NOT REMOVE THE SCREWS IN STEP 4 IFTHE COLUMN IS PRESSURIZED. YOU CAN CAUSESERIOUS INJURIES AND DAMAGE TO THE PEDESTAL.4. Use a 3 mm hex key to remove the four socket head cap screws from thetop plate over the cylinders being replaced. Set the top plate and screwsaside.4 Screws InEach Top Plate5. Remove the cylinder from the column.4-20 User Manual
SP-2000/X-YMaintenance And Repair6. Install the replacement cylinder.7. Install the top plate and tighten the four screws in the plate with a 3 mm hexkey.8. Install the head and payload. Refer to the User Manual for your head andthe documentation for your payload equipment.9. Presurize and balance the pedestal as described in chapter 3 of this manual.User Manual 4-21
Page 1 and 2:
SP-2000/X-YAutoCam PedestalOperatio
Page 3 and 4:
Critical Data For SP-2000/X-YMass (
Page 5 and 6:
WarrantyVinten, Incorporated (Vinte
Page 7 and 8:
Table Of ContentsSP-2000/X-Y Pedest
Page 9 and 10:
Table Of ContentsCustomer Responsib
Page 11 and 12:
1 Safety & IntroductionUser Manual
Page 13 and 14:
SP-2000/X-YSafety & IntroductionOth
Page 15 and 16:
SP-2000/X-YSafety & IntroductionCAU
Page 17 and 18:
SP-2000/X-YSafety & IntroductionWar
Page 19 and 20:
SP-2000/X-YSafety & IntroductionHOW
Page 21 and 22:
SP-2000/X-YSafety & IntroductionThi
Page 23 and 24:
SP-2000/X-YSafety & IntroductionThe
Page 25 and 26:
SP-2000/X-YSafety & Introductionbig
Page 27 and 28:
SP-2000/X-YSafety & IntroductionTyp
Page 29 and 30:
2 OperationUser Manual 2-1
Page 31 and 32:
SP-2000/X-YOperationOrientationAs a
Page 33 and 34:
SP-2000/X-YOperation2. Press the St
Page 35 and 36: SP-2000/X-YOperationAfter clearing
Page 37 and 38: SP-2000/X-YOperationPedestal Active
Page 39 and 40: SP-2000/X-YOperationTargetingTarget
Page 41 and 42: 3 InstallationUser Manual 3-1
Page 43 and 44: SP-2000/X-YInstallationFloor Prepar
Page 45 and 46: SP-2000/X-YInstallation4. Using two
Page 47 and 48: SP-2000/X-YInstallation4. Plug the
Page 49 and 50: SP-2000/X-YInstallation4. Continue
Page 51 and 52: SP-2000/X-YInstallationMCB Controll
Page 53 and 54: SP-2000/X-YInstallation2. Connect t
Page 55 and 56: SP-2000/X-YInstallationFinishing Up
Page 57 and 58: SP-2000/X-YInstallationThis page le
Page 59 and 60: SP-2000/X-YInstallation3. Install a
Page 61 and 62: SP-2000/X-YInstallationTechflex Inc
Page 63 and 64: SP-2000/X-YInstallationThis page le
Page 65 and 66: SP-2000/X-YInstallationCrating The
Page 67 and 68: 4 Maintenance And RepairUser Manual
Page 69 and 70: SP-2000/X-YMaintenance And RepairOt
Page 71 and 72: SP-2000/X-YMaintenance And RepairTh
Page 73 and 74: SP-2000/X-YMaintenance And Repair
Page 75 and 76: SP-2000/X-YMaintenance And RepairRe
Page 81 and 82: SP-2000/X-YMaintenance And RepairNo
Page 83 and 84: SP-2000/X-YMaintenance And Repair3.
Page 85: SP-2000/X-YMaintenance And RepairTh
Page 89 and 90: SP-2000/X-YMaintenance And RepairWA
Page 93 and 94: SP-2000/X-YMaintenance And RepairIf
Page 97 and 98: SP-2000/X-YMaintenance And RepairBa
Page 99 and 100: SP-2000/X-YMaintenance And Repair10
Page 103 and 104: SP-2000/X-Y IndexNumerics4-Channel
Page 105 and 106: SP-2000/X-Y IndexTarget Sensor Cali
show all

SP-2000/X-Y AutoCamâ¢ Pedestal - Vinten Radamec

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

SP-2000/X-Y AutoCamâ¢ Pedestal - Vinten Radamec