SP-2000/X-Y AutoCam™ Pedestal - Vinten Radamec

SP-2000/X-YMaintenance And RepairCalibrationCollision BumpersAll four detectors are connected to the detector circuit board mounted just belowthe cable clamp.#2(North Side)Calibration Pots#1#3Cover Screws#4The potentiometer for each of the four collision detectors can be adjusted withoutremoving the cover. Or, you can remove the cover (using a 3/16” hex key)for greater access. The collision bumpers are numbered 1 through 4 as shownabove and the corresponding pots are numbered 1 through 4 from left to right.1. Starting with #1, turn the pot clockwise slowly until the adjacent LED is asteady red. Turn the pot counterclockwise slowly until the LED is a steadygreen.2. Press firmly on bumper #1 with your hand or foot. The #1 LED will turnred as you press on the bumper and back to green when you release. If theLED tends to flicker when you release the bumper, readjust pot #1.3. Repeat these steps for the other three bumpers and pots.4-24 User Manual