SP-2000/X-Y AutoCamâ¢ Pedestal - Vinten Radamec

More documents

Recommendations

Info

SP-2000/X-YInstallationUnloading The Pedestal1. Twist clockwise on each of the three Emergency Stop Switches to releasethem (they will pop up when released).2. Install the E-STOP bypass jumper plug on the Power/Data In connector onthe control panel as shown below. Without this jumper plug the E-STOPlogic will prevent battery powered operation.E-STOP Bypass Jumper3. The cable skirts around the pedestal base (4 in total) must be raised fullybefore you drive the pedestal off the base of the crate and down the ramp.For each skirt, loosen the thumbscrews, raise the skirt and tighten thethumbscrews.3-6 User Manual
SP-2000/X-YInstallation4. Plug the MCB controller cable into the Power/Data MCB connector on thepedestal. Set the Local/Remote switch on the MCB to Remote.LOCREMROTATEWARNING: The MCB controller MUST always be inRemote when you turn on the SP-2000/X-Y pedestal.5. Press and hold the Standby/Charge (yellow) button on the pedestal until thelight comes on and stays on. If the batteries are discharged (typically below24V on the control panel voltmeter) and the pedestal will not turn on, referto AC Powered Unloading below.6. Press the Run (green) button on the pedestal and the light will come on andthe pedestal circuits will initialize. Wait about 30 seconds until all threewheels have initialized (the North wheel is first, followed by the Westwheel then the East wheel) before moving on to the next step.User Manual 3-7
Page 1 and 2: SP-2000/X-YAutoCam PedestalOperatio
Page 3 and 4: Critical Data For SP-2000/X-YMass (
Page 5 and 6: WarrantyVinten, Incorporated (Vinte
Page 7 and 8: Table Of ContentsSP-2000/X-Y Pedest
Page 9 and 10: Table Of ContentsCustomer Responsib
Page 11 and 12: 1 Safety & IntroductionUser Manual
Page 13 and 14: SP-2000/X-YSafety & IntroductionOth
Page 15 and 16: SP-2000/X-YSafety & IntroductionCAU
Page 17 and 18: SP-2000/X-YSafety & IntroductionWar
Page 19 and 20: SP-2000/X-YSafety & IntroductionHOW
Page 21 and 22: SP-2000/X-YSafety & IntroductionThi
Page 23 and 24: SP-2000/X-YSafety & IntroductionThe
Page 25 and 26: SP-2000/X-YSafety & Introductionbig
Page 27 and 28: SP-2000/X-YSafety & IntroductionTyp
Page 29 and 30: 2 OperationUser Manual 2-1
Page 31 and 32: SP-2000/X-YOperationOrientationAs a
Page 33 and 34: SP-2000/X-YOperation2. Press the St
Page 35 and 36: SP-2000/X-YOperationAfter clearing
Page 37 and 38: SP-2000/X-YOperationPedestal Active
Page 39 and 40: SP-2000/X-YOperationTargetingTarget
Page 41 and 42: 3 InstallationUser Manual 3-1
Page 43 and 44: SP-2000/X-YInstallationFloor Prepar
Page 45: SP-2000/X-YInstallation4. Using two
Page 49 and 50: SP-2000/X-YInstallation4. Continue
Page 51 and 52: SP-2000/X-YInstallationMCB Controll
Page 53 and 54: SP-2000/X-YInstallation2. Connect t
Page 55 and 56: SP-2000/X-YInstallationFinishing Up
Page 57 and 58: SP-2000/X-YInstallationThis page le
Page 59 and 60: SP-2000/X-YInstallation3. Install a
Page 61 and 62: SP-2000/X-YInstallationTechflex Inc
Page 63 and 64: SP-2000/X-YInstallationThis page le
Page 65 and 66: SP-2000/X-YInstallationCrating The
Page 67 and 68: 4 Maintenance And RepairUser Manual
Page 69 and 70: SP-2000/X-YMaintenance And RepairOt
Page 71 and 72: SP-2000/X-YMaintenance And RepairTh
Page 73 and 74: SP-2000/X-YMaintenance And Repair
Page 75 and 76: SP-2000/X-YMaintenance And RepairRe
Page 81 and 82: SP-2000/X-YMaintenance And RepairNo
Page 83 and 84: SP-2000/X-YMaintenance And Repair3.
Page 87 and 88: SP-2000/X-YMaintenance And Repair6.
Page 89 and 90: SP-2000/X-YMaintenance And RepairWA
Page 93 and 94: SP-2000/X-YMaintenance And RepairIf
Page 97 and 98:
SP-2000/X-YMaintenance And RepairBa
Page 99 and 100:
SP-2000/X-YMaintenance And Repair10
Page 101 and 102:
SP-2000/X-YMaintenance And RepairTh
Page 103 and 104:
SP-2000/X-Y IndexNumerics4-Channel
Page 105 and 106:
SP-2000/X-Y IndexTarget Sensor Cali
show all

SP-2000/X-Y AutoCamâ¢ Pedestal - Vinten Radamec

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

SP-2000/X-Y AutoCamâ¢ Pedestal - Vinten Radamec