SP-2000/X-Y AutoCam™ Pedestal - Vinten Radamec

SP-2000/X-YInstallationMCB Controller MountingAfter the pan/tilt head is mounted, the MCB controller is mounted to a rightangle bar that is attached to the head.Mounting BarMounting Bracket1. Attach the mounting bracket to the bottom of the head using the fourscrews and flat washers provided. Tighten the screws with a 3/16” hex key.2. Insert the right angle mounting bar into the bracket and tighten the clampscrews with a 3/16” hex key. The final positioning of the bar (left/right andup/down) will depend on the camera position and can be adjusted later.3. Mount the MCB controller on the bar and tighten the clamp.4. Plug the MCB controller cable into the Local Control Data connector onthe SP-2000 control panel.User Manual 3-11