SP-2000/X-Y AutoCam™ Pedestal - Vinten Radamec

SP-2000/X-YMaintenance And RepairCylinder ReplacementWhen you check the column balance, if you find that gas needs to be added frequently,you may need to replace one or more of the three cylinders in the column.Remove the yellow dust caps and test each cylinder with a pressure gauge. Ifone or more cylinders is low relative to the others, use the following procedureto replace it.1. Lower the column to minimum height and power down the pedestal.2. Fully discharge the gas from the cylinders using the procedure in chapter 3.3. Remove the payload and head from the pedestal. Refer to the documentationfor the payload equipment and the User Manual for the pan/tilt headfor specific instructions.DANGER: DO NOT REMOVE THE SCREWS IN STEP 4 IFTHE COLUMN IS PRESSURIZED. YOU CAN CAUSESERIOUS INJURIES AND DAMAGE TO THE PEDESTAL.4. Use a 3 mm hex key to remove the four socket head cap screws from thetop plate over the cylinders being replaced. Set the top plate and screwsaside.4 Screws InEach Top Plate5. Remove the cylinder from the column.4-20 User Manual