SP-2000/X-Y AutoCam™ Pedestal - Vinten Radamec

SP-2000/X-YInstallationCrating The Pedestal1. Place the base of the crate close to the pedestal, leaving room for the ramp.2. Using two or more people, insert the two pins at the end of the ramp intothe mating holes in the base of the crate. Unfold the ramp onto the floor.3. Install the first side panel of the crate (with the large foam pad) as a guideto help you position the pedestal on the base.First Side PanelLarge Foam PadMates With Pedestal4. The cable skirts around the pedestal base (4 in total) must be raised fullybefore you drive the pedestal up the ramp onto the crate base. For eachskirt, loosen the thumbscrews, raise the skirt and tighten the thumbscrews.5. With the MCB controller in Remote, press and latch Standby/Charge, andthen press Run.6. Allow 30 seconds for the pedestal circuits to initialize.7. Switch the MCB controller to Local and Drive mode. Drive the pedestal tothe base of the ramp. Use Rotate mode to line up the pedestal with theramp. As shown in the photo on the previous page, the North side of thepedestal goes up the ramp first.8. Carefully drive the pedestal up the center of the ramp. Note: Even with thecable skirts raised, they may hang up on the bottom of the ramp and also atthe top. If this happens, have an assistant pull up slightly on the pedestal sothat the skirt will clear.9. When the pedestal is correctly positioned on the base of the crate, switch toRotate mode on the MCB controller and then switch to Remote. Push downand latch all three Emergency STOP switches.10. Remove the E-STOP bypass jumper plug.User Manual 3-25