SP-2000/X-Y AutoCam™ Pedestal - Vinten Radamec

SP-2000/X-YInstallation3. Install an E-STOP switch for each pedestal at a convenient location close tothe joystick panel. If you are using dual controllers, install a second E-STOP switch for each pedestal at the second controller location.E-STOP SwitchE-STOPJumperE-STOP cable to power supply4. Clearly label the E-STOP switches so that the operator can see at a glancewhich switch connects to each of the pedestals.5. Connect the E-STOP cable from the E-STOP loop connector on power supply#1 to E-STOP switch #1.6. If you have a single controller, install the E-STOP jumper on the open connectoron E-STOP switch #1. If you have a sencond controller, connectanother E-STOP cable from the first E-STOP switch #1 to the second E-STOP switch #1 and install the E-STOP jumper on the second switch.7. Repeat steps 5 and 6 for the other pedestals.User Manual 3-19