SP-2000/X-Y AutoCam⢠Pedestal - Vinten Radamec
SP-2000/X-Y AutoCam⢠Pedestal - Vinten Radamec
SP-2000/X-Y AutoCam⢠Pedestal - Vinten Radamec
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>SP</strong>-<strong>2000</strong>/X-YInstallationCalibrating The Collision BumpersIgnore this section if your pedestal has the electromechanical type of bumper.See page 1-7 if you are not sure which type of bumper you have.Before the <strong>SP</strong>-<strong>2000</strong>/X-Y is put into service it is essential for safety reasons thatthe collision bumper detection circuits are calibrated. Each cable skirt (4 total)has an internal collision detector. All four detectors are connected to the detectorcircuit board mounted just below the cable clamp.Collision Bumper Calibration PotsUse the calibration procedure in chapter 4.3-16 User Manual
Change language