Operating instructions - EWM Hightec Welding GmbH

Machine description – quick overviewMachine control – Operating elements4.3.1 Covered operating elements4 31617M 3.73MaterialGasWiresec8sec5 7 6 10 9DYNsecsecsec11 1218SuperpulsJOB-LISTsec2 15 113sec14sec19Figure 4-4Item Symbol Description 01 Select welding parameters buttonThis button is used to select the welding parameters depending on the welding processand operating mode used.2 Signal light, gas pre-flow timeSetting range 0.0 s to 20.0 s3 Signal light, start program (P START)• Wire speed:1% to 200% of the main program P A• Correction of the arc length -9.9 V to +9.9 V4 sec Signal light, start timeSetting range, absolute 0.0 s to 20.0 s (0.1 s increments)5 sec Signal light, slope time program P STARTto main program P ASetting range 0.0 s to 20.0 s (0.1 s increments)6 Signal light, main program (P A)• Wire speed WF-min. to WF-max.• Correction of the arc length -9.9 V to +9.9 V7 DYN Signal light, dynamicsSetting range -40 to +408 sec Signal light, duration of main program P ASetting range 0.0 s to 20.0 s (0.1 s increments).Used e.g. in connection with the super pulse function9 Signal light, reduced main program (P B)• Wire speed:1% to 200% of the main program P A• Correction of the arc length -9.9 V to +9.9 V10 sec Signal light, duration reduced main program P BSetting range 0.0 s to 20.0 s (0.1 s increments).Used e.g. in connection with the super pulse function.11 sec Signal light, slope time program P A(or P B) to end program P ENDSetting range 0.0 s to 20.0 s (0.1 s increments)12 Signal light, end program (P END)• Wire speed:1% to 200% of the main program P A• Correction of the arc length -9.9 V to +9.9 V13 sec Signal light, duration of end program P ENDSetting range 0.0 s to 20.0 s (0.1 s increments)14 Signal light, gas post-flow timeSetting range 0.0 s to 20.0 s24099-005234-EW50116.04.2012