Operating instructions - EWM Hightec Welding GmbH

Design and functionMIG/MAG weldingDisplaySetting/selectionRamp time for wire inching0 = normal inching (10s ramp time)1 = fast inching (3s ramp time) (Ex works)Block program "0"0 = P0 enabled (Ex works)1 = P0 blockedProgram limitationPrograms 1 to max. 15Ex works: 15Special cycle in the special latched and non-latched operating modes0 = normal (previous) non-latched/latched (Ex works)1 = WF3 cycle for non-latched/latchedEnable special jobs SP1 to SP30 = no enabling (Ex works)1 = enabling of Sp1-3Correction operation, threshold value setting0 = correction operation switched off (Ex works)1 = correction operation on"Main program (PA)" flashingProgram changeover with standard torch0 = no program changeover (Ex works)1 = special latched2 = specific latched special (n cycle active)Lat. and sp. lat. tapping start0 = no latched tapping start (Ex works)1 = latched tapping start possibleSpecial latched tapping time0 = tapping function switched off1 = 300ms (Ex works)2 = 600msHOLD function0 = HOLD values are not displayed1 = HOLD values are displayed (Ex works)Program selection with standard torch trigger0 = no program selection (Ex works)1 = program selection possibleSwitching the operating mode and welding type using the wire feed control0 = Switching the operating mode and welding type using the wire feed control andprogram 0 (factory setting).1 = Switching the operating mode and welding type using the wire feed control andprograms 0-15.Alternative remote control coding (FRC)0 = no alternative remote control coding (works setting)1-15 = alternative remote control codingSoftware key switch0 = system complete1 = system not complete (Ex works)70099-005234-EW50116.04.2012