Click to Download User Manual. - Home

4 Loading originals and printmedia2 Place the original face down on the scanner glass and align it withthe registration guide at the top left corner of the glass.This chapter introduces you how to load originals and print media intoyour machine.This chapter includes:• Loading originals• Selecting print media• Loading paper• Setting the paper size and typeLoading originalsYou can use the scanner glass or DADF to load an original for copying,scanning, and sending a fax.On the scanner glassMake sure that no originals are in the DADF. If an original is detected inthe DADF, the machine gives it priority over the original on the scannerglass. To get the best scan quality, especially for colored or gray-scaledimages, use the scanner glass.1 Lift and open the scanner lid.3 Close the scanner lid.Note• Leaving the scanner lid open while copying may affect copyquality and toner consumption.• Dust on the scanner glass may cause black spots on theprintout. Always keep it clean. (Page 10.2)• If you are copying a page from a book or magazine, lift thescanner lid until its hinges are caught by the stopper and thenclose the lid. If the book or magazine is thicker than 30 mm,start copying with the lid open.In the DADFUsing the DADF, you can load up to 50 sheets of 75 g/m 2 (20 lb) paperfor one job.When you use the DADF:• Do not load paper smaller than 174(W) x 128(L) mm or larger than218(W) x 356(L) mm.• Do not attempt to load the following types of paper:- carbon-paper or carbon-backed paper- coated paper- onion skin or thin paper- wrinkled or creased paper- curled or rolled paper- torn paper• Remove all staples and paper clips before loading.• Make sure any glue, ink, or correction fluid on the paper is completelydry before loading.• Do not load originals that include different sizes or weights of paper.• Do not load booklets, pamphlets, transparencies, or documentshaving other unusual characteristics.4.1