Operating Instructions - Snap-on Equipment

PC Software OverviewCommands 1-10Commands provide access to the gas analyzer software, just as the buttons do,but the commands are tied more directly to actions.1 Manual MetersBegins the process of checking gases (CO 2 , CO, HC, NO, O 2 , Air FuelRatio (AFR), RPM, Temperature) from the vehicle and displaying,printing, or saving the results.2 TSI TestBegins the process of performing the Two Speed Idle Test.3 Idle TestBegins the process of performing the Idle Only Test.4 New CustomerUse to input information about a new customer.5 Find CustomerUse to search for an existing customer.6 Gas CalibrationDisplays options to perform a leak check, gas calibration, or install anew NO x sensor.7 HelpDisplays online help.Error/Status Message8 SetupUse to configure the hardware, calibration, TSI and miscellaneoussettings. Setup requires a password.9 State StandardsDisplays the emissions standards for various states.10 ExitCloses the gas analyzer software program.The bar at the bottom left displays error or status messages. In the illustration thesystem is “Ready”.Software Info and Customer NameThe bar at the bottom middle contains the name of the software and the activecustomer.Date and TimeThe bar at the bottom right provides the current date and time.3A-3