Operating Instructions - Snap-on Equipment

PC Automatic TestsThe system warns you and the test restarts if:— Low flow is detected,or— Minimum dilution requirements are not metor— RPM values are outside the range for more than two consecutiveseconds (or the time set in Time Allowed Outside RPM Range) or atotal of ten seconds (or the number set in Total Time Allowed OutsideRPM Range).Pass/FailFGA allows a maximum of three restarts (or the number set in MaxRestarts). A fourth restart (or the number in Max Restarts+1) causes theTSI Test to abort.✓ Select the Tachometer button at any time to reconfigure thetachometer. The test then restarts.✓ Press the Abort button at any time to stop the test.When the TSI Test ends, FGA proceeds to test completion, discussed inTest Completed, page 3D-6.Test Completed13. When the TSI Simulation is complete, the Test Completed windowdisplays.Figure 3D-6: Test Completed Screen14. Remove the tachometer lead and sample probe from the vehicle.15. Press OK.3D-6