Operating Instructions - Snap-on Equipment

PC Software InstallationSystem RequirementsMinimum requirements for PC systems to run the FGA software include:• IBM 486 DX or 100% compatible— IBM 586 or higher is strongly recommended• Windows 95/98/2000/XP• 64 MB of RAM or more• FGA software requires 30 MB minimum available hard drive disk space• VGA or SVGA video card— Local bus video recommended,• CD-ROM drive• Microsoft mouse or 100% compatible• 1 available RS-232 portInstalling FGA✓ You should be familiar with installing software before you attemptinstallation. You should also be familiar with PC hardware.1. Start Windows.— It is very important to make sure that no other programs are loaded intomemory before beginning the FGA install. Close all applications, otherthan Windows, before proceeding. Verify that nothing else is loaded byholding down the Alt key and pressing the Tab key. If the screen does notchange, Windows is the only program running.✓ If problems occur during the installation process it may benecessary to remove all programs loaded in under the ProgramsStart Up group. Keep in mind, the more applications running whileyou are working with FGA, the slower the software will run.2. Select Run from the Windows 95/98/2000 Start menu.— See Figure 3B-1.3. Type D:\Setup.exe (or appropriate CD-ROM drive letter) in the Open fieldand press OK.— You may also use the Browse button to select the setup file from theCD-ROM drive.Figure 3B-1: Starting the Installation— The setup program begins running and displays several introductoryscreens. The software license agreement screen appears.4. Press Agree.— The license must be agreed to before the setup continues.3B-2