Operating Instructions - Snap-on Equipment

PC MaintenanceZip / Postal Code— Shop zip or postal code.Phone #— Shop phone number.Fax #— Shop fax number.Message— Enter up to a four line sales message that prints on FGA printedreports.Language— Select the language in which to display all text.Metric— Select metric to show FGA information in metric measurements. (Thedefault is English measurements: inch, gallon, pound etc.)Setup4. When all Shop Information is entered, select OK to store the information.This section describes general setup, standards, new NO x sensor, and unitdiagnostics.General SetupGeneral Setup specifies settings for general operation as well as calibration andTSI/Idle parameters.To operate properly, the FGA gas analyzer and emissions test must be configuredusing the Setup window. It is extremely important that you change only what isneeded, because incorrect setup configuration adversely affects the analyzer.To begin the Setup,1. Press the Gas button and choose Service Utilities > Setup from the menu.orSelect the 8 Setup command.— The system then prompts you to enter a password.Figure 3G-12: Service Password Screen2. Enter the password and press Continue. The default is “STATION” (alluppercase).— The Setup window opens.✓ For more information about the password, see Change Password,page 3H-1.Use the Setup window to configure FGA for normal operation.3G-8