Operating Instructions - Snap-on Equipment

Pocket PC Maintenance3. Seal the probe tip.4. Press Start to begin the test.A visual indication shows that the leak check is in progress. When the leakcheck is completed a message displays with the result.5. When the leak check has successfully completed, remove the probe capfrom the exhaust probe.6. Select Continue to continue using FGA.If the leak check fails,Figure 2G-12: Leak Check Pass ScreenFigure 2G-13: Leak Check Fail Screen1. Inspect the exhaust hose, exhaust probe, fittings, and connection to thefilter bowl.2. Remove the hose from the sample port on the filter and seal the inlet.Repeat the leak check. If it now passes, the vehicle sample hose or probehas a leak. If it fails again, go to Step 3.2G-8