Operating Instructions - Snap-on Equipment

PC MaintenanceZero Purge Time(s)—Length of time the analyzer takes to clear outresidual gases before calibration. Default is 60 and cannot be changed.Meter / Strip Chart Recording Interval—Enter the length, in seconds,between recording measurements. See Strip Chart Display Setup,page 3C-7 for further details.Pump Off Delay—Number of seconds the gas bench pump remains onafter exiting Manual Meters and Strip Chart as well as at the end of the TSITest. This is recommended to help reduce HC hangup and help purgewater from the analyzer.Minimum Oil Temperature—The minimum oil temperature requiredbefore the Temperature Test can begin countdown. Applies only if an oiltemperature kit is installed.Temperature Test Length—Length of the Temperature Test in seconds.Applies only if an oil temperature kit is installed.Minimum Temperature Test RPM—Minimum RPM allowed during thetest. Applies only if an oil temperature kit is installed.Maximum Temperature Test RPM—Maximum RPM allowed during thetest. Applies only if an oil temperature kit is installed.Maximum HC Hangup—Maximum HC Hangup allowed while performingHC Hangup Test.HC Test Length—Length of the HC Test in seconds.Minimum Dilution—The minimum dilution required during a TSI Test.Default is 6.3G-13