DTM for EtherNet/IP Scanner Devices - Hilscher

Error Codes 121/149
9.5 General Error CIP Codes
The following table contains the possible General Error Codes defined
within the EtherNet/IP standard.
General CIP Error Codes
General Error
Codes (hexa
dezcimal)
Status Name Description
00 Success The service has successfully been performed by the specified object.
01 Connection failure A connection-elated service failed. This happened at any location along
the connection path.
02 Resource unavailable Some resources which where required for the object to perform the
requested service were not available.
03 Invalid parameter value See status code 0x20, which is usually applied in this situation.
04 Path segment error A path segment error has been encountered. Evaluation of the supplied
path information failed.
05 Path destination The path references an unknown object class, instance or structure
unknown
element causing the abort of path processing.
06 Partial transfer Only a part of the expected data could be transferred.
07 Connection lost The connection for messaging has been lost.
08 Service not supported The requested service has not been implemented or has not been
defined for this object class or instance.
09 Invalid attribute value Detection of invalid attribute data
0A Attribute list error An attribute in the Get_Attribute_List or Set_Attribute_List response
has a status not equal to 0.
0B Already in requested The object is already in the mode or state which has been requested by
mode/state
the service
0C Object state conflict The object is not able to perform the requested service in the current
mode or state
0D Object already exists It has been tried to create an instance of an object which already
exists.
0E Attribute not settable It has been tried to change an non-modifiable attribute.
0F Privilege violation A check of permissions or privileges failed.
10 Device state conflict The current mode or state of the device prevents the execution of the
requested service.
11 Reply data too large The data to be transmitted in the response buffer requires more space
than the size of the allocated response buffer
12 Fragmentation of a The service specified an operation that is going to fragment a primitive
primitive value
data value, i.e. half a REAL data type.
13 Not enough data The service did not supply all required data to perform the specified
operation.
14 Attribute not supported An unsupported attribute has been specified in the request
15 Too much data More data than was expected were supplied by the service.
16 Object does not exist The specified object does not exist in the device.
17 Service fragmentation Fragmentation sequence for this service is not currently active for this
sequence not in
progress
data.
18 No stored attribute The attribute data of this object has not been saved prior to the
data
requested service.
19 Store operation failure The attribute data of this object could not be saved due to a failure
during the storage attempt.
DTM for EtherNet/IP Scanner Devices | Configuration of EtherNet/IP Scanner Devices
DOC061201OI06EN | Revision 6 | English | 2010-08 | Released | Public © Hilscher, 2006-2010