DTM for EtherNet/IP Scanner Devices - Hilscher

Settings 32/149
3.2.4.4 Driver Parameters for netX Driver - TCP/IP Connection
The settings of the driver parameters for the TCP/IP connection are made
via the netX Driver / TCP Connection configuration dialog.
Open the TCP Connection dialog via navigation area Settings >
Driver > netX Driver.
The dialog netX Driver is displayed:
Select TCP Connection.
Figure 11: netX Driver > TCP Connection
Parameter Meaning Range of Value / Value
Enable TCP Connector
(Restart of ODM
required)
checked: The netX Driver can communicate via the TCP/IP
interface.
unchecked: The netX Driver can not communicate via the
TCP/IP interface.
If the check mark for Enable TCP Connector is set or
removed, then the ODM server must be restarted 1 , to make
the new setting valid.
_______
1
Restart the ODM server via the ODMV3 Tray Application:
-In the foot line click to using the right mouse key.
- In the context menu select Service > Start.
Select IP Range Via Select IP Range already created IP ranges can be
selected.
Via an additional IP range can be added.
Via an IP range can be deleted.
Scan Timeout [ms] With the scan timeout can be set, how long to wait for a
response during a connection is established.
checked,
unchecked;
Default:
unchecked
10 … 10000 [ms];
Default: 100 ms
DTM for EtherNet/IP Scanner Devices | Configuration of EtherNet/IP Scanner Devices
DOC061201OI06EN | Revision 6 | English | 2010-08 | Released | Public © Hilscher, 2006-2010