DTM for EtherNet/IP Scanner Devices - Hilscher

Getting Started 19/149
# Step Short Description For detailed information
see section
10 Assign Scanner
device once more
(with firmware)
11 Configure Adapter
device
12 Configure Scanner
device
In the Scanner DTM configuration dialog:
- select Settings > Device Assignment,
- select Scan,
- select the Scanner device (with loaded
firmware),
- therefore check the appropriate checkbox,
- select Apply,
- close the Scanner DTM configuration dialog via
OK.
Configure the Adapter device.
- Double click to the device icon of the Adapter.
- The Adapter DTM configuration dialog is
displayed.
In the Adapter DTM configuration dialog:
- select Configuration > Modules (for modular
DTM only),
- configure the modules of the modular
EtherNet/IP Adapter,
- select Configuration > Electronic Keying,
- select the keying method and configure it if
necessary,
- select Configuration > Connection,
- configure the connection points,
- select Configuration > Assembly,
- configuren Instance ID and Data length,
- configure a modular device according to the
description Configuring a modular EtherNet/IP
Adapter,
- close the Adapter DTM configuration dialog via
OK.
Configure the Scanner device.
- Double click to the device icon of the Scanner.
- The Scanner DTM configuration dialog is
displayed.
In the Scannner DTM configuration dialog:
- select Configuration > Network Settings,
- set the Network Settings,
- select Configuration > Scanlist,
- select the required device/s and set the
IP address of the adapter,
- select Configuration > Process data,
- set symbolic names for the configured modules
or signals.
- select Configuration > Address table,
- set the device address, if necessay,
- select Configuration > Scanner Settings,
- set the Scanner Settings.
- close the Scanner DTM configuration dialog via
OK.
13 Save project Depending of the frame application.
For the configuration software:
- select File > Save.
14 Connect Scanner
device
15 Download
Configuration
Depending of the FDT Container.
For netDevice:
- right click to the device icon of the Scanner,
- select context menu entry Connect.
Depending of the FDT Container.
For netDevice:
- right click to the device icon of the Scanner,
- select context menu entry Download.
Selecting the Device once
more (with Firmware)
(See “User Manual Generic
EtherNet/IP Adapter DTM
for EtherNet/IP Adapter
Devices and Modular
Generic EtherNet/IP Adapter
DTM for modular
EtherNet/IP Adapter
Devices)
Configuring Device
Parameters
Network Settings
Scanlist
Process Data
Address Table
Scanner Settings
(See User Manual of the
Frame Application)
Connecting/Disconnecting
Device
DTM for EtherNet/IP Scanner Devices | Configuration of EtherNet/IP Scanner Devices
DOC061201OI06EN | Revision 6 | English | 2010-08 | Released | Public © Hilscher, 2006-2010
Page
40
-
22
48
49
51
52
55
-
90
Download Configuration 91