DTM for EtherNet/IP Scanner Devices - Hilscher

Online Functions 92/149
8.3 Start /Stop Communication
You can manually start or stop the communication between a EtherNet/IP
Scanner device and EtherNet/IP Adapter devices.
• Start Communication is enabled, if the communication has been
stopped before or if the configuration requires this (Controlled release of
communication).
• Stop Communication is enabled, if the communication has been
started.
To start or to stop the communication, proceed as follows:
Start Communication
1. Connecting Device:
Note: To start the communication of the device at the bus manually, an
online connection from the EtherNet/IP Scanner DTM to the EtherNet/IP
Scanner device is required.
Further information can be found in the Connecting/Disconnecting Device
section on page 90.
2. Select Additional Functions > Service > Start Communication from
the context menu (right mouse click).
The device communicates at the bus.
Stop Communication
1. Select Additional Functions > Service > Stop Communication from
the context menu (right mouse click).
The communication of the device at the bus is stopped.
DTM for EtherNet/IP Scanner Devices | Configuration of EtherNet/IP Scanner Devices
DOC061201OI06EN | Revision 6 | English | 2010-08 | Released | Public © Hilscher, 2006-2010