DTM for EtherNet/IP Scanner Devices - Hilscher

Extended Diagnosis 67/149
6.3 IniBatch-Status
Figure 40: Extended Diagnosis > [Folder Name] > IniBatch Status Display
Name Description
Communication Channel Number of the communication channel used by the device.
Current State 0 =Idle;
1 =IniBatch packets in progress;
2 =Retrying to send last packet;
3 = Error
IniBatch Result 0 = Ok;
1 = No DBM file;
2 = No Packet table;
3 = No data set available;
4 = Data set is shorter than packet length;
5 = Packet Buffer is shorter than Packet length;
6 = Invalid packet destination;
7 = Logical queue not defined
8 = Send packet failed;
9 = Too many retries;
10 = Error in confirmation packet status
OpenDbm Result Error when opening the IniBatch data base
Under "OpenDbm Result" the error code is typed in, when
"IniBatch Result" == "No DBM file" (1) is.
SendPacket Result Error when sending a packet
Under "SendPacket Result" the error code is typed in, when
"IniBatch Result" == “send packet failed" (8) is.
Confirmation Result Confirmation error when sending packets
Under "Confirmation Result" the package specific error code
from the ulSta is typed in, when "IniBatch Result " == "Error in
confirmation packet status" (10) is.
Last Packet Number Value depends by the communication system.
Last Packet Command Value depends by the communication system.
Last Packet Length Value depends by the communication system.
Last Packet Destination Value depends by the communication system.
Table 31: Extended Diagnosis > [Folder Name] > IniBatch Status
The task status "Confirmation Result" is bus specific. The other task
statuses are rcx-related error codes.
DTM for EtherNet/IP Scanner Devices | Configuration of EtherNet/IP Scanner Devices
DOC061201OI06EN | Revision 6 | English | 2010-08 | Released | Public © Hilscher, 2006-2010