DTM for EtherNet/IP Scanner Devices - Hilscher

Configuration 56/149
4.6.1 Start of Bus Communication
4.6.2 Application Monitoring
Figure 31: Scanner Settings > Start of Bus Communication
If Automatically by device is selected, the EtherNet/IP Scanner device
starts with the data exchange on the bus after the initializing has been
ended.
When Controlled by application is selected, the application program must
activate the data exchange on the bus.
Note: The setting options under Start of Bus Communication for client
specific variants of the configuration software can differ from the setting
options displayed here.
Figure 32: Scanner Settings > Application Monitoring
The Watchdog time determines the time within which the device watchdog
must be re-triggered from the application program while the application
program monitoring is activated. When the watchdog time value is equal to
0 the watchdog is deactivated and the application program monitoring is
deactivated too.
The permissible range of values of the watchdog time is 20 to 65535. By
default the watchdog time value equals to 1000 ms.
Watchdog time Range of Value / Value
Permissible range of values 20 … 65535 ms
Default 1000 ms
The software watchdog is deactivated. 0 ms
Table 22: Range of Value / Value for the Watchdog time
Note: The setting options under Application Monitoring for client
specific variants of the configuration software can differ from the setting
options displayed here.
DTM for EtherNet/IP Scanner Devices | Configuration of EtherNet/IP Scanner Devices
DOC061201OI06EN | Revision 6 | English | 2010-08 | Released | Public © Hilscher, 2006-2010