DTM for EtherNet/IP Scanner Devices - Hilscher

Settings 34/149
3.2.5 Configure netX Driver
The following steps are required to configure the netX Driver:
USB/RS232 Connection
To set the driver parameters for an USB/RS232 connection note:
Note: Adjust the driver parameters netX Driver USB/RS232 only if they
differ from the default settings. After saving the changed driver
parameters, these parameters are used for the device assignment when
scanning devices.
TCP/IP Connection
For setting the driver parameters for a TCP/IP connection:
1. Select Settings > Driver > netX Driver > TCP Connection.
2. Set IP Adddress of the device:
Add an IP Range via Select IP Range .
3. Under IP Range Configuration > IP Address enter the IP Address of
the device (Use IP Range is unchecked).
Or
4. Set IP Range:
Check Use IP Range.
Under IP Range Configuration > IP Address enter the start address
(left side) and the ending address of the IP scanning range (right side).
5. Click Save, to save the IP address or the IP range.
After saving the changed driver parameters, these parameters are used
for the device assignment when scanning devices.
DTM for EtherNet/IP Scanner Devices | Configuration of EtherNet/IP Scanner Devices
DOC061201OI06EN | Revision 6 | English | 2010-08 | Released | Public © Hilscher, 2006-2010