DTM for EtherNet/IP Scanner Devices - Hilscher

Error Codes 122/149
General CIP Error Codes
General Error
Codes (hexa
dezcimal)
Status Name Description
1A Routing failure, request
packet too large
1B Routing failure,
response packet too
large
1C Missing attribute list
entry data
1D Invalid attribute value
list
1E Embedded service
error
The service request packet was too large for transmission on a network
in the path to the destination. The routing device was forced to abort
the service.
The service response packet was too large for transmission on a
network in the path from the destination. The routing device was forced
to abort the service.
The service did not supply an attribute in a list of attributes that was
needed by the service to perform the requested behavior.
The service returns the list of attributes containing status information
for invalid attributes.
An embedded service caused an error.
1F Vendor specific error A vendor specific error has occurred. This error should only occur when
none of the other general error codes can correctly be applied.
20 Invalid parameter A parameter which was associated with the request was invalid. The
parameter does not meet the requirements of the CIP specification
and/or the requirements defined in the specification of an application
object.
21 Write-once value or
medium already written
An attempt was made to write to a write-once medium for the second
time, or to modify a value that cannot be changed after being
established once.
22 Invalid reply received An invalid reply is received. Possible causes can for instance be
among others a reply service code not matching the request service
code or a reply message shorter than the expectable minimum size.
23-24 Reserved Reserved for future extension of CIP standard
25 Key failure in path The key segment (i.e. the first segment in the path) does not match the
destination module. More information about which part of the key check
failed can be derived from the object specific status.
26 Path size Invalid Path cannot be routed to an object due to lacking information or
too much routing data have been included.
27 Unexpected attribute in
list
It has been attempted to set an attribute which may not be set in the
current situation.
28 Invalid member ID The Member ID specified in the request is not available within the
specified class/ instance or attribute
29 Member cannot be set A request to modify a member which cannot be modified has occurred
2A Group 2 only server
general failure
This DeviceNet-specific error cannot occur in EtherNet/IP
2B-CF Reserved Reserved for future extension of CIP standard
D0-FF Reserved for object
class and service
errors
An object class specific error has occurred.
Table 61: General CIP Error Codes
DTM for EtherNet/IP Scanner Devices | Configuration of EtherNet/IP Scanner Devices
DOC061201OI06EN | Revision 6 | English | 2010-08 | Released | Public © Hilscher, 2006-2010