DTM for EtherNet/IP Scanner Devices - Hilscher
DTM for EtherNet/IP Scanner Devices - Hilscher
DTM for EtherNet/IP Scanner Devices - Hilscher
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Configuration 47/149<br />
4 Configuration<br />
4.1 Overview Configuration<br />
Configuration Steps<br />
The following steps are required to configure the parameters of the<br />
<strong>EtherNet</strong>/<strong>IP</strong> <strong>Scanner</strong> device using the <strong>EtherNet</strong>/<strong>IP</strong> <strong>Scanner</strong> <strong>DTM</strong>:<br />
1. Set the Network Settings.<br />
2. Configure the scanlist.<br />
3. Set the Process Data.<br />
4. Set the <strong>Scanner</strong> Settings.<br />
Configuration Dialog Panes<br />
The table below gives an overview <strong>for</strong> the Configuration dialog panes<br />
descriptions:<br />
Section Page<br />
Network Settings 48<br />
Scanlist 49<br />
Process Data 51<br />
Address Table 52<br />
<strong>Scanner</strong> Settings 55<br />
Table 17: Descriptions of the Dialog Panes Configuration<br />
Figure 24: Navigation Area - Configuration<br />
Notice the descriptions in the section Configuration Steps on page 18.<br />
<strong>DTM</strong> <strong>for</strong> <strong>EtherNet</strong>/<strong>IP</strong> <strong>Scanner</strong> <strong>Devices</strong> | Configuration of <strong>EtherNet</strong>/<strong>IP</strong> <strong>Scanner</strong> <strong>Devices</strong><br />
DOC061201OI06EN | Revision 6 | English | 2010-08 | Released | Public © <strong>Hilscher</strong>, 2006-2010