VessRAID Setup - Promise Technology, Inc.

Reported Event Corrective Action
291
Chapter 9: Troubleshooting
Blowers are functioning Normal.
normally
Blowers are NOT installed Reinstall the fan. If the fan does not turn, replace it.
See page 238.
Blower status is unknown Check for airflow out of the cooling unit. If there is
none, check for proper installation.
Cache
BBU flushing has started VessRAID’s cache is being flushed.
BBU flushing has ended VessRAID’s cache has been flushed.
BBU flushing has failed VessRAID’s cache could not be flushed. Check your
cache flush interval setting. See page 96 (WebPAM
PROe) or page 147 (CLU).
Controller
The controller
parameter(s) changed by
user
The controller has new
crash information
Controller temperature is
above the threshold/
warning threshold
Controller temperature is
above the critical
threshold
Disk Array
New disk array has been
created
Disk array has been
deleted
Disk array has been
added
Disk array has been
removed
Disk array settings have
been changed
The user successfully changed controller settings.
See page 96 (WebPAM PROe) or page 147 (CLU).
Check the event logs. See page 53 and 54 (WebPAM
PROe) or page 186 (CLU)
The VessRAID controller is overheating. Check for
airflow around and through the controller, and verify
that all fans are working. Replace fans as needed.
The VessRAID controller is seriously overheating.
Check for airflow around and through the controller,
and verify that all fans are working. Replace fans as
needed.
Result of settings or user action. Normal.
Result of settings or user action. Normal.
Result of settings or user action. Normal.
The physical drives of the disk array were removed
from the enclosure.
The user successfully disk array settings. See
page 120 (WebPAM PROe) or page 163 (CLU).