VessRAID Setup - Promise Technology, Inc.

Setting Up Serial Cable Connections
23
Chapter 2: VessRAID Installation
Serial communication enables the Command Line Interface (CLI) and Command
Line Utility (CLU) on your PC to monitor and control the VessRAID. The
VessRAID package includes a RJ11-to-DB9 serial data cable.
Figure 15. A serial connector is located on the controller
RJ11 Serial Connector
To set up a serial cable connection:
1. Attach the RJ11 end of the serial data cable to the RJ11 serial connector on
the controller.
2. Attach the DB9 end of the serial data cable to a serial port on the Host PC or
Server.
This completes the serial cable connection. See “Setting up the Serial
Connection” on page 27.