VessRAID Setup - Promise Technology, Inc.

VessRAID 1000i Series Product Manual
Reported Event Corrective Action
Drive Interface Controller
Drive-interface controller Normal.
found
Drive-interface controller Restart the VessRAID. See page 94 (WebPAM
is NOT found
PROe) or page 207 (CLU). If this message appears
repeatedly, contact Technical Support. See page 319.
Drive-interface
Normal.
diagnostics has passed
Drive-interface
Restart the VessRAID. See page 94 (WebPAM
diagnostics has failed PROe) or page 207 (CLU). If this message appears
repeatedly, contact Technical Support. See page 319
Drive-interface controller Drive-to-controller parity error. If this message
has generated a general/ appears repeatedly, contact Technical Support. See
data parity error. page 319.
Enclosure
Enclosure temperature is The VessRAID is overheating. Check for airflow
above the threshold/ around and through the VessRAID, and verify that all
warning threshold fans are working. Replace fans as needed.
Enclosure temperature is The VessRAID is seriously overheating. Check for
above the critical airflow around and through the VessRAID, and verify
threshold
that all fans are working. Replace fans as needed.
Enclosure temperature is Normal.
within the normal range
Event Log
Event logging is enabled Event logging has been successfully enabled.
Event logging is disabled Event logging has been disabled.
Event log buffer is cleared The event log was cleared.
in RAM
Event log buffer is cleared The non-volatile RAM event log was cleared.
in NVRAM
Event log buffer is cleared The MDD (disk drive) event log was cleared.
in MDD
Host Interface Controller
Host-interface controller
has detected bus reset
The initiator sent a reset command. If this message
appears repeatedly, contact Technical Support. See
page 319.
292