 Apple Technician Guide - tim.id.au

More documents

Recommendations

Info

Replacement Caution: When connecting cables, make sure they are fully connected. Replacement Caution: To avoid a short to the logic board, be sure to place EMI gasket on camera cable—positioned precisely where shown— after cable is fully connected to logic board. Then, replace black shim next to connector. Low-Profile Solid Platform Flex • Use black stick and gentle rocking motion to release tension to remove cable. • Keep connector level to board and press evenly on platform to install. Examples: • optical drive flex cable • trackpad flex cale 2010-08-05 MacBook Pro (15-inch, 2.53 GHz, Mid 2009) Take Apart — General Information 118
2010-08-05 Icon Legend The following icons are used in this chapter: Icon Meaning Temperature Concerns Warning or Caution Check mark; make sure you do this The normal operating temperature of this computer is well within national and international safety standards. Nevertheless, customers may be concerned about the generated heat. To prevent an unneeded repair, you can compare a customer’s computer to a running model, if available, at your repair site. For more information on temperature concerns and customer perception, refer to Knowledge Base article 30612 “Apple Portables: Operating Temperature.” http://docs.info.apple.com/article.html?artnum=30612 Replacement Steps When there are no replacement steps listed, replace parts in the exact reverse order of the Removal procedure. Note About Images in This Guide Because a pre-production model was used for the illustrations in this manual, you may notice small differences between the image pictured and the computer you are servicing. Screw Sizes All screw sizes shown are approximate and represent the total length of the screw. MacBook Pro (15-inch, 2.53 GHz, Mid 2009) Take Apart — General Information 119
Page 1 and 2:
apple Apple Technician Guide MacBoo
Page 3 and 4:
MacBook Pro (15-inch, 2.53 GHz, Mid
Page 5 and 6:
Hard Drive Not Recognized/Not Mount
Page 7 and 8:
Removal 188 Replacement 190 Left Sp
Page 9 and 10:
2010-08-05 Manual Updates Update 11
Page 11 and 12:
2010-08-05 Apple Technician Guide I
Page 13 and 14:
apple Apple Technician Guide Basics
Page 15 and 16:
2010-08-05 Note About Images in Thi
Page 17 and 18:
2010-08-05 Transferring the Serial
Page 19 and 20:
2010-08-05 Display Panels Customers
Page 21 and 22:
2010-08-05 The Glass Panel Warning:
Page 23 and 24:
2010-08-05 General Troubleshooting
Page 25 and 26:
2010-08-05 Functional Overview Refe
Page 27 and 28:
2010-08-05 Liquid Contact Indicator
Page 29 and 30:
2010-08-05 Display Issue: Pixel Ano
Page 31 and 32:
2010-08-05 Symptom Charts Follow th
Page 33 and 34:
2010-08-05 8. Verify adapter status
Page 35 and 36:
2010-08-05 3. Reseat customer memor
Page 37 and 38:
2010-08-05 Intermittent Shutdown Un
Page 39 and 40:
2010-08-05 Quick Check Symptom Quic
Page 41 and 42:
2010-08-05 7. Check if sleep event
Page 43 and 44:
2010-08-05 4. Reset SMC and verify
Page 45 and 46:
2010-08-05 11. Verify with reseated
Page 47 and 48:
2010-08-05 11. Battery status LEDs
Page 49 and 50:
2010-08-05 3. Boot in Safe Mode wit
Page 51 and 52:
2010-08-05 6. Disconnect display as
Page 53 and 54:
2010-08-05 Deep Dive Check Result A
Page 55 and 56:
2010-08-05 Noise / Hum / Vibration
Page 57 and 58:
2010-08-05 Burnt Smell / Odor Unlik
Page 59 and 60:
2010-08-05 Communications Ethernet
Page 61 and 62:
2010-08-05 AirPort/Bluetooth: Defec
Page 63 and 64:
2010-08-05 No/Poor Wireless Signal
Page 65 and 66:
2010-08-05 2. System Preferences ha
Page 67 and 68: 2010-08-05 3. Isolate AirPort card
Page 69 and 70: 2010-08-05 8. (Bluetooth) Enable Bl
Page 71 and 72: 2010-08-05 Display Display Anomalie
Page 73 and 74: 2010-08-05 Deep Dive: Distorted/Blu
Page 75 and 76: 2010-08-05 7. Substitute a known-go
Page 77 and 78: 2010-08-05 Blank / No Video Unlikel
Page 79 and 80: 2010-08-05 5. Inspect LVDS connecto
Page 81 and 82: 2010-08-05 Cosmetic Defects Quick C
Page 83 and 84: 2010-08-05 4. After reseating hard
Page 85 and 86: 2010-08-05 Hard Drive Noisy Unlikel
Page 87 and 88: 2010-08-05 Deep Dive Check Result A
Page 89 and 90: 2010-08-05 2. Can optical drive rea
Page 91 and 92: 2010-08-05 Optical Drive Noisy Unli
Page 93 and 94: 2010-08-05 Optical Drive Not Perfor
Page 95 and 96: 2010-08-05 Input/Output Devices USB
Page 97 and 98: 2010-08-05 4. Reseat cable and chec
Page 99 and 100: 2010-08-05 6. Does the select butto
Page 101 and 102: 2010-08-05 2. Reset SMC and verify
Page 103 and 104: 2010-08-05 Apple Remote Inoperable
Page 105 and 106: 2010-08-05 3. Verify that you now g
Page 107 and 108: 2010-08-05 SD (Secure Digital) Memo
Page 109 and 110: 2010-08-05 3. Unlock the customer S
Page 111 and 112: 2008-09-18 Mechanical Issues: Therm
Page 113 and 114: 2008-09-18 Deep Dive Check Result A
Page 115 and 116: apple Apple Technician Guide Take A
Page 117: Horizontal Install • Pull connect
Page 121 and 122: Removal Caution: To prevent scratch
Page 123 and 124: Replacement 1 When replacing a bott
Page 125 and 126: Removal 1 Using the Torx Plus Tampe
Page 127 and 128: 3 Press battery indicator light but
Page 129 and 130: Removal 1 Loosen 2 captive screws t
Page 131 and 132: 6 Follow safe handling: • Do not
Page 133 and 134: 3 Attach connector and insert hard
Page 135 and 136: First Steps Remove: • Bottom case
Page 139 and 140: Replacement 1 Install cards at an a
Page 141 and 142: Removal 1 Disconnect 2 screws. 2 Pe
Page 149 and 150: 4 Peel and lift cable off optical d
Page 151 and 152: 8 Open the display to 90 degrees, a
Page 153 and 154: Display Hinge Behavior The MacBook
Page 157 and 158: 4 Tilt up end of clutch cover as yo
Page 161 and 162: Replacement 1 Make sure thermal pad
Page 163 and 164: Removal 1 Remove 4 (3-mm) screws. 2
Page 165 and 166: Removal 1 Remove 3 screws • 3 (3.
Page 167 and 168: 5 With a black stick, carefully pry
Page 169 and 170:
Removal 1 With a black stick or fin
Page 171 and 172:
Removal 1 Using black stick, discon
Page 173 and 174:
2010-08-05 Note on Foam: A small pi
Page 175 and 176:
First Steps Remove: • Bottom case
Page 177 and 178:
Page 179 and 180:
Caution: The LVDS cable/ lock bar i
Page 181 and 182:
10 Remove 8 torx T6 logic board scr
Page 183 and 184:
Page 185 and 186:
Replacement Important: New heatsink
Page 187 and 188:
Page 189 and 190:
5 Support trackpad and flex cable a
Page 191 and 192:
4 On the palm rest, insert one stic
Page 193 and 194:
Page 195 and 196:
3 Move speaker out of the way. 4 Di
Page 197 and 198:
Removal Use black stick to pry micr
Page 199 and 200:
Removal 1 Remove 2 torx T6 screws (
Page 201 and 202:
Removal 1 Remove 2 screws: • 10-m
Page 203 and 204:
Removal 1 Place tape over battery b
Page 205 and 206:
Removal With the first steps comple
Page 207 and 208:
Bottom Case 922-9043 Hard Drive Bra
Page 209 and 210:
2010-08-05 External Views Front Vie
Page 211 and 212:
2008-08-27 Screw Chart 076-1327 Phi
Page 213 and 214:
2010-08-05 Screw Location Diagrams
Page 215 and 216:
LVDS Cable Guide, Fan, and Camera C
Page 217 and 218:
Trackpad, Midwall Snap, and Midwall
Page 219 and 220:
Battery Indicator Light Board and C
Page 221:
AirPort Card and Antenna Board Scre
show all

 Apple Technician Guide - tim.id.au

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?