 Apple Technician Guide - tim.id.au

More documents

Recommendations

Info

Replacement 1 Route flex cable through opening. 2 Spiral and pivot trackpad into place. Important: Minimize rubbing edges of trackpad against top case while installing. This could cause invisible cracks to form in the glass of the trackpad. 3 Loosely insert 8 short Phillips #000 screws into new flexures. Tighten a little bit. 2010-08-05 MacBook Pro (15-inch, 2.53 GHz, Mid 2009) Take Apart — Trackpad 190
4 On the palm rest, insert one sticky (Post-It) note into gap on each of the four sides of trackpad. 5 Fold sticky notes over so that top case can be laid flat. 2010-08-05 MacBook Pro (15-inch, 2.53 GHz, Mid 2009) Take Apart — Trackpad 191
Page 1 and 2:
apple Apple Technician Guide MacBoo
Page 3 and 4:
MacBook Pro (15-inch, 2.53 GHz, Mid
Page 5 and 6:
Hard Drive Not Recognized/Not Mount
Page 7 and 8:
Removal 188 Replacement 190 Left Sp
Page 9 and 10:
2010-08-05 Manual Updates Update 11
Page 11 and 12:
2010-08-05 Apple Technician Guide I
Page 13 and 14:
apple Apple Technician Guide Basics
Page 15 and 16:
2010-08-05 Note About Images in Thi
Page 17 and 18:
2010-08-05 Transferring the Serial
Page 19 and 20:
2010-08-05 Display Panels Customers
Page 21 and 22:
2010-08-05 The Glass Panel Warning:
Page 23 and 24:
2010-08-05 General Troubleshooting
Page 25 and 26:
2010-08-05 Functional Overview Refe
Page 27 and 28:
2010-08-05 Liquid Contact Indicator
Page 29 and 30:
2010-08-05 Display Issue: Pixel Ano
Page 31 and 32:
2010-08-05 Symptom Charts Follow th
Page 33 and 34:
2010-08-05 8. Verify adapter status
Page 35 and 36:
2010-08-05 3. Reseat customer memor
Page 37 and 38:
2010-08-05 Intermittent Shutdown Un
Page 39 and 40:
2010-08-05 Quick Check Symptom Quic
Page 41 and 42:
2010-08-05 7. Check if sleep event
Page 43 and 44:
2010-08-05 4. Reset SMC and verify
Page 45 and 46:
2010-08-05 11. Verify with reseated
Page 47 and 48:
2010-08-05 11. Battery status LEDs
Page 49 and 50:
2010-08-05 3. Boot in Safe Mode wit
Page 51 and 52:
2010-08-05 6. Disconnect display as
Page 53 and 54:
2010-08-05 Deep Dive Check Result A
Page 55 and 56:
2010-08-05 Noise / Hum / Vibration
Page 57 and 58:
2010-08-05 Burnt Smell / Odor Unlik
Page 59 and 60:
2010-08-05 Communications Ethernet
Page 61 and 62:
2010-08-05 AirPort/Bluetooth: Defec
Page 63 and 64:
2010-08-05 No/Poor Wireless Signal
Page 65 and 66:
2010-08-05 2. System Preferences ha
Page 67 and 68:
2010-08-05 3. Isolate AirPort card
Page 69 and 70:
2010-08-05 8. (Bluetooth) Enable Bl
Page 71 and 72:
2010-08-05 Display Display Anomalie
Page 73 and 74:
2010-08-05 Deep Dive: Distorted/Blu
Page 75 and 76:
2010-08-05 7. Substitute a known-go
Page 77 and 78:
2010-08-05 Blank / No Video Unlikel
Page 79 and 80:
2010-08-05 5. Inspect LVDS connecto
Page 81 and 82:
2010-08-05 Cosmetic Defects Quick C
Page 83 and 84:
2010-08-05 4. After reseating hard
Page 85 and 86:
2010-08-05 Hard Drive Noisy Unlikel
Page 87 and 88:
Page 89 and 90:
2010-08-05 2. Can optical drive rea
Page 91 and 92:
2010-08-05 Optical Drive Noisy Unli
Page 93 and 94:
2010-08-05 Optical Drive Not Perfor
Page 95 and 96:
2010-08-05 Input/Output Devices USB
Page 97 and 98:
2010-08-05 4. Reseat cable and chec
Page 99 and 100:
2010-08-05 6. Does the select butto
Page 101 and 102:
2010-08-05 2. Reset SMC and verify
Page 103 and 104:
2010-08-05 Apple Remote Inoperable
Page 105 and 106:
2010-08-05 3. Verify that you now g
Page 107 and 108:
2010-08-05 SD (Secure Digital) Memo
Page 109 and 110:
2010-08-05 3. Unlock the customer S
Page 111 and 112:
2008-09-18 Mechanical Issues: Therm
Page 113 and 114:
Page 115 and 116:
apple Apple Technician Guide Take A
Page 117 and 118:
Horizontal Install • Pull connect
Page 119 and 120:
2010-08-05 Icon Legend The followin
Page 121 and 122:
Removal Caution: To prevent scratch
Page 123 and 124:
Replacement 1 When replacing a bott
Page 125 and 126:
Removal 1 Using the Torx Plus Tampe
Page 127 and 128:
3 Press battery indicator light but
Page 129 and 130:
Removal 1 Loosen 2 captive screws t
Page 131 and 132:
6 Follow safe handling: • Do not
Page 133 and 134:
3 Attach connector and insert hard
Page 135 and 136:
First Steps Remove: • Bottom case
Page 137 and 138:
First Steps Remove: • Bottom case
Page 139 and 140: Replacement 1 Install cards at an a
Page 141 and 142: Removal 1 Disconnect 2 screws. 2 Pe
Page 143 and 144: First Steps Remove: • Bottom case
Page 149 and 150: 4 Peel and lift cable off optical d
Page 151 and 152: 8 Open the display to 90 degrees, a
Page 153 and 154: Display Hinge Behavior The MacBook
Page 157 and 158: 4 Tilt up end of clutch cover as yo
Page 161 and 162: Replacement 1 Make sure thermal pad
Page 163 and 164: Removal 1 Remove 4 (3-mm) screws. 2
Page 165 and 166: Removal 1 Remove 3 screws • 3 (3.
Page 167 and 168: 5 With a black stick, carefully pry
Page 169 and 170: Removal 1 With a black stick or fin
Page 171 and 172: Removal 1 Using black stick, discon
Page 173 and 174: 2010-08-05 Note on Foam: A small pi
Page 179 and 180: Caution: The LVDS cable/ lock bar i
Page 181 and 182: 10 Remove 8 torx T6 logic board scr
Page 185 and 186: Replacement Important: New heatsink
Page 189: 5 Support trackpad and flex cable a
Page 195 and 196: 3 Move speaker out of the way. 4 Di
Page 197 and 198: Removal Use black stick to pry micr
Page 199 and 200: Removal 1 Remove 2 torx T6 screws (
Page 201 and 202: Removal 1 Remove 2 screws: • 10-m
Page 203 and 204: Removal 1 Place tape over battery b
Page 205 and 206: Removal With the first steps comple
Page 207 and 208: Bottom Case 922-9043 Hard Drive Bra
Page 209 and 210: 2010-08-05 External Views Front Vie
Page 211 and 212: 2008-08-27 Screw Chart 076-1327 Phi
Page 213 and 214: 2010-08-05 Screw Location Diagrams
Page 215 and 216: LVDS Cable Guide, Fan, and Camera C
Page 217 and 218: Trackpad, Midwall Snap, and Midwall
Page 219 and 220: Battery Indicator Light Board and C
Page 221: AirPort Card and Antenna Board Scre
show all

 Apple Technician Guide - tim.id.au

Create successful ePaper yourself

Delete template?

Save as template?