manuale per l'installatore - 1/3 tipologie d'installazione - 2/3 software ...

need to install two (refer to
installation plans to know how
many sensors are needed).
• N. of Injectors : indicates the
total number of installed gas
injectors. Mainly they are 4 and
this is the set value. A message
will indicate the technician the
number of FLY SF ECU he has
to install according to the
selected injectors number.
Finish and verify the introduced
values, then click on NEXT to continue.
A similar section could be
activated from the main
screen, outside the aided procedure,
by selecting Setting up -->
Type of Installation
NOTE: By clicking ADVANCED
key in the installation section, it is
possible to set operation limits
concerning the rpm signal and the
MAP manifold pressure (picture
4.4c). Normally this operation has
not to be carried out unless indicated
by BRC technicians. In
detail you could set:
• Rpm Min: it is the minimum
rpm value in the maps: usually
it is suitable to set a value of
about 300 rpm under the idling
condition value;
• Rpm Max: it is the maximum
rpm value in the maps: usually
it is suitable to set a value of
about 500-600giri/min under
the vehicle rev up value;
• MAP Min: it is the minimum
absolute pressure value (mbar)
Fig. 4.4b - Aided procedure - installation and iniectiors calibration
Pic. 4.4c - Aided Procedure – injectors and installation calibration by clicking on
ADVANCED key in the installation section
of the suction manifold in the
maps: usually it is suitable to
set a value of about 200-
300mbar under MAP value at
idling;
• MAP Max: it is the maximum
absolute pressure value (mbar)
of the suction manifold in the
maps: introduce the maximum
value of the achievable manifold
pressure. In case of vacuum
engines set 1000 while for
LPG turbo ones set 1700.
17